Abstract:<p>Predicting the mechanical failure of parts in service requires understanding their deformation behavior, and associated dynamic microstructural evolution up to the near-atomic scale. Solutes are known to interact with defects generated by plastic deformation, thereby affecting their displacement throughout the microstructure and hence the material's mechanical response to solicitation. This effect is studied here in a polycrystalline Ni-based superalloy with two different Nb contents that lead to a significant change in their creep lifetime. Creep testing at 750°C and 600 MPa shows that the high-Nb alloy performs better in terms of creep strain rate. Considering the similar initial microstructures, the difference in mechanical behavior is attributed to a phase transformation that occurs along planar faults, controlled by the different types of stacking faults and alloy composition. Electron channeling contrast imaging reveals the presence of stacking faults in both alloys. Microtwinning is observed only in the low-Nb alloy, rationalizing in part the higher creep strain rate. In the high-Nb alloy, atom probe tomography evidences two different types of stacking faults based on their partitioning behavior. Superlattice intrinsic stacking faults were found enriched in Nb, Co, Cr and Mo while only Nb and Co was segregated at superlattice extrinsic stacking faults. Based on their composition, a local phase transformation occurring along the faults is suggested, resulting in slower creep strain rate in the high-Nb alloy. In comparison, mainly superlattice intrinsic stacking faults enriched in Co, Cr, Nb and Mo were found in the low-Nb alloy. Following the results presented here, and those available in the literature, an atomic-scale driven alloy design approach that controls and promotes local phase transformation along planar faults at 750°C is proposed, aiming to design superalloys with enhanced creep resistance.</p>

Crystal plasticity phase-field simulation of creep property of Co-base single crystal superalloy with pre-rafting

Phase-field simulation of γ' precipitates rafting and creep property of Co-base superalloys

Crystal plasticity phase-field simulation of rafting and creep properties with a continuous change of the mismatch strain in a Co-Al-W superalloy

Three-dimensional Elastoplastic Phase-Field Simulation of Γ′ Rafting and Creep Deformation

A Phase-Field Model for Creep Behavior in Nickel-Base Single-Crystal Superalloy: Coupled with Creep Damage

Crystal plasticity phase-field simulation of slip system anisotropy during creep of Co-Al-V monocrystal alloy under multidirectional strain

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Constitutive modeling of creep behavior in single crystal superalloys: Effects of rafting at high temperatures

Atomic Structure and Elemental Segregation Behavior of Creep Defects in a Co-Al-W-based Single Crystal Superalloys under High Temperature and Low Stress

Creep properties and deformation mechanisms of single-crystalline $γ^\prime$-strengthened superalloys in dependence of the Co/Ni ratio

The Creep Deformation Behavior of a Single-Crystal Co–Al–W-base Superalloy at 900 °C

Enhanced creep performance in a polycrystalline superalloy driven by atomic-scale phase transformation along planar faults

Superior creep resistance in a γ′-strengthened Co-based single-crystal superalloy at 760°C and ∼90% yield strength

Stress driving element redistribution and rafting of γ′ phase in Ni–Al–Mo superalloy

Microstructure and Creep Performance of a Multicomponent Co-Based L1 2-Ordered Intermetallic Alloy

Homogenization Effects by Co Additions to High Temperature and Low Stress Creep Performance of a 4Th-Generation Ni-based Single Crystal Superalloys

Rafting and redissolution of γ' phase in Ni-Al alloy under external stress

Understanding creep of a single-crystalline Co-Al-W-Ta superalloy by studying the deformation mechanism, segregation tendency and stacking fault energy

Correlating microstructure recovery to rejuvenation of high-temperature creep properties in a crept single-crystal superalloy

Phase and grain size inhomogeneity and their influences on creep behavior of Co–Cr–Mo alloy additive manufactured by electron beam melting

Degradation effects of the rafts and dislocation network on creep property of single crystal superalloy at medium temperature