Abstract:<p>Predicting the mechanical failure of parts in service requires understanding their deformation behavior, and associated dynamic microstructural evolution up to the near-atomic scale. Solutes are known to interact with defects generated by plastic deformation, thereby affecting their displacement throughout the microstructure and hence the material's mechanical response to solicitation. This effect is studied here in a polycrystalline Ni-based superalloy with two different Nb contents that lead to a significant change in their creep lifetime. Creep testing at 750°C and 600 MPa shows that the high-Nb alloy performs better in terms of creep strain rate. Considering the similar initial microstructures, the difference in mechanical behavior is attributed to a phase transformation that occurs along planar faults, controlled by the different types of stacking faults and alloy composition. Electron channeling contrast imaging reveals the presence of stacking faults in both alloys. Microtwinning is observed only in the low-Nb alloy, rationalizing in part the higher creep strain rate. In the high-Nb alloy, atom probe tomography evidences two different types of stacking faults based on their partitioning behavior. Superlattice intrinsic stacking faults were found enriched in Nb, Co, Cr and Mo while only Nb and Co was segregated at superlattice extrinsic stacking faults. Based on their composition, a local phase transformation occurring along the faults is suggested, resulting in slower creep strain rate in the high-Nb alloy. In comparison, mainly superlattice intrinsic stacking faults enriched in Co, Cr, Nb and Mo were found in the low-Nb alloy. Following the results presented here, and those available in the literature, an atomic-scale driven alloy design approach that controls and promotes local phase transformation along planar faults at 750°C is proposed, aiming to design superalloys with enhanced creep resistance.</p>

Precipitate dissolution during deformation induced twin thickening in a CoNi-base superalloy subject to creep

Creep properties and deformation mechanisms of single-crystalline $γ^\prime$-strengthened superalloys in dependence of the Co/Ni ratio

Influence of composition and precipitation evolution on damage at grain boundaries in a crept polycrystalline Ni-based superalloy

Creep Residual Life Prediction of a Nickel-Based Single Crystal Superalloy Based on Microstructure Evolution

Based on Damage Caused by Microstructure Evolution During Long-Term Thermal Exposure to Analyze and Predict Creep Behavior of Ni-based Single Crystal Superalloy

Defect Interactions and Formation of Nanometer Γ Phases Within Γ' Precipitates in Ni-Co-based Superalloys During Creep

Effect of microstructure on temperature dependence of deformation behavior in polycrystalline CoNi-based superalloy

High-Ti inducing local Eta-phase transformation and creep-twinning in CoNi-based superalloys

Deformation features of a nickel-base superalloy single crystal during compression creep

Hot deformation characteristics and dynamic recrystallization mechanisms of a Co–Ni-based superalloy

Deformation Mechanisms in a Co-rich Nickel Based Superalloy with Different Size of Γ׳ Precipitates

Temperature-dependent Deformation Mechanisms of Γ′ Phases in a Newly Developed NiCoCr-based Superalloy

Plastic Deformation Behaviors and Mechanical Properties of Advanced Single Crystalline CoNi-base Superalloys

Twins and Β0 Precipitation Effects on the Lamellar Degradation in Tnm Alloy During Creep

High-Temperature Structural Stabilities of Ni-Based Single-Crystal Superalloys Ni–Co–Cr–Mo–W–Al–Ti–Ta with Varying Co Contents

High-Temperature Creep Behavior of a Nickel-Based Single-Crystal Superalloy with Small-Angle Deviation from [111] Orientation

Enhanced creep performance in a polycrystalline superalloy driven by atomic-scale phase transformation along planar faults

Hot Compression Behaviors and Deformation Mechanisms of a Ni–Co-based Superalloy with Columnar Grains

Twins and β 0 precipitation effects on the lamellar degradation in TNM alloy during creep

Creep behaviors and deformation mechanisms at intermediate temperatures in a novel γ‐γ' nickel‐based superalloy

Effect of μ precipitation and γ′ evolution on intra/intergranular strength of Ni-Co-Cr-based superalloys after 800 °C thermal exposure