Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

A Textured Surface with Oil Inflow and Outflow Function Designed for Starved Lubrication

A Pocket-Textured Surface for Improving the Tribological Properties of Point Contact under Starved Lubrication

The Effect of Laser Texturing of Steel Surfaces on Film Lubriction Based on Stribeck Curves

Experimental Investigation on Effects of Surface Texturing on Lubrication of Initial Line Contacts

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

The Synergetic Effects of Surface Texturing and MoDDP Additive Applied to Ball-on-Disk Friction Subject to Both Flooded and Starved Lubrication Conditions

A Design of Partial Textured Surface on Gear Washers for Reducing Friction and Wear under Low Speed and Heavy Load Conditions

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Study of grease lubricated journal bearing with partial surface texture

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Simulation-based research on enhancing lubricity: investigating wettability and textured surfaces in alkane lubricants under boundary lubrication conditions

Topology optimization of AISI 4140 steel with surface texture filled by multi-solid lubricants for enhancing tribological properties

Influence of surface texture on pocket pairs lubrication performance of cylindrical roller bearings

Friction Behavior of a Textured Surface against Several Materials under Dry and Lubricated Conditions

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Generation method and antifriction performance evaluation of discrete micro-pit surface texture based on high speed ball-end milling process

Tribological behaviors of laser textured surface under different lubrication conditions for rotary compressor

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Simulation and Experimental Validation of the Effect of Surface Texture on Fluid Film Formation