Abstract:Springback is one of the most important problems that should be compensated in sheet metal forming process with the increasing application of advanced high strength steels and light-weight alloys. In the finite element analyses for the springback, accurate modeling of Bauschinger effect, transient behavior and permanent softening under cyclic loading has been recognized as the most critical hardening behavior in the constitutive modeling aspect. However, if parts of these hardening behavior are not well modelled, is the accuracy of springback prediction seriously deteriorated? To answer this question, in this paper the significance of Bauschinger effect and transient behavior, permanent softening and unloading modulus in springback prediction were estimated using the springback problem of U-draw/bending simulations proposed at Numisheet2011 Benchmark. A recent anisotropic non-linear kinematic (ANK) model [Zang S, Guo C, Thuillier S, Lee M. A model of one-surface cyclic plasticity and its application to springback prediction. Int J Mech Sci 2011;53:425–35.] was adopted to estimate the significance of hardening behavior and unloading modulus because of its special feature. The ANK model can predict exactly the same monotonous stress–strain curves for different hardening schemes, while different Bauschinger effect and transient behavior under one-dimensional cyclic loading can be also modelled. This feature is quite suitable to quantitatively evaluate the effects of the aforementioned hardening behaviors in springback prediction. Initial anisotropy is described by the anisotropic yield function Yld2000-2d. The unloading behavior is also considered by defining Young's modulus as a function of equivalent plastic strain. Several quantitative analyses were carried out to distinguish the effect of each hardening component and unloading elastic modulus scheme. Finally, the predicted springback by different models were compared with experiments for both as-received and pre-strained DP780 steel sheets.

Springback prediction of stamping GH3536 alloy sheet with complex surface

Springback prediction of advanced high strength steel part based on Yoshida-Uemori hardening model

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

A Comparison Study of Different Hardening Models in Springback Prediction for Stamping of the Third Generation Ultra High Strength Steel

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Springback Prediction Using the Split-Ring Test Based on A Combined Anisotropic Hardening Model

A new predicting model study on U-shaped stamping springback behavior subjected to steady-state temperature field

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Identification of Advanced Constitutive Model Parameters Through Global Optimization Approach for DP780 Steel Sheet

Springback Prediction of Automobile Body Panel Based on Yoshida-Uemori Material Model

Study on Process Parameters and Springback Rule for Stamping of High Strength Steel Sheet

Spring Back Behavior of Large Multi-Feature Thin-Walled Part in Rigid-Flexible Sequential Loading Forming Process

Analysis on the Effects of Numerical Simulation Precision on Springback Prediction

The FEM simulation and analysis of springback in age forming of 7050 aluminum alloy

Springback Prediction and Compensation for the Third Generation of UHSS Stamping Based on a New Kinematic Hardening Model and Inertia Relief Approach

Springback prediction method for double-curved workpiece considering plate anisotropy in multi-point forming

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Springback prediction of 7075 aluminum alloy V-shaped parts in cold and hot stamping

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

Comparison of Material Models for Spring Back Prediction in an Automotive Panel Using Finite Element Method