Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In scientific studies, sheet metal is usually considered as a two-dimensional body. Thus, it is accepted that material properties are in most cases regarded homogeneous in thickness direction. However, a gradation of certain properties becomes apparent when going beyond the standard characterization methods for sheet metals, which can for example, influence the springback behavior and the thinning of the sheet after forming. Thus, the aim of this work is to further improve the prediction accuracy of springback after forming in simulations, by implementing several inhomogeneous properties over the sheet thickness in an existing material model. For this purpose, the entire procedure from the identification of the inhomogeneous properties for describing the gradation to the implementation in a numerical model and its validation by comparing experimental and simulated bending operations is carried out on a DC04 cold-forming steel in order to prove its influence on the springback behavior. It is shown that including graded material properties in simulations does indeed have an impact on the prediction quality of springback and that the information about inhomogeneous properties can be provided by existing characterization methods with a high local resolution like electron backscatter diffraction or X-ray stress analysis. In a further step, it was possible to validate the improvement in numerical accuracy by comparing the prediction of the springback angle from both the existing and the extended model with experimental bending results. Both the initial model as well as the model supplemented with the 3D properties provide a good prediction accuracy in the solution heat treated material state. For the predeformed material, however, the initial numerical model predicts a springback angle of about 13°, which deviates remarkably from the experimentally obtained mean value of about 17°. The extended model delivers a significantly improved accuracy in springback prediction in relation to the initial prediction (deviation of 4°) with a minor deviation of only about 0.8°, which proves the importance of considering the gradation of material properties in thickness direction for an overall higher dimensional accuracy of sheet metal products.

Comparison of Material Models for Spring Back Prediction in an Automotive Panel Using Finite Element Method

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Investigation on the effect of friction and material behavior models on the springback simulation precision: application to automotive part B-Pillar and material TRIP800 steel

Spring Back Behavior of Large Multi-Feature Thin-Walled Part in Rigid-Flexible Sequential Loading Forming Process

A new predicting model study on U-shaped stamping springback behavior subjected to steady-state temperature field

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Analytical prediction of springback based on residual differential strain during sheet metal bending

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

Springback prediction and compensation method for anisotropy sheet in multi-point forming

Effects of Hardening Model and Variation of Elastic Modulus on Springback Prediction in Roll Forming

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Springback prediction method for double-curved workpiece considering plate anisotropy in multi-point forming

Springback Control in Complex Sheet-Metal Forming Based on Advanced High-Strength Steel

Springback compensation for a vehicle’s steel body panel

Finite element modeling for analyzing the production of high-strength steel sheets for automobile parts

The prediction and control on the springback of the front inner panel of automobile at multi-steps stamping

Research on springback characteristic in flexible multi-points 3D stretch-bending process

Research on the Springback Behavior of 316LN Stainless Steel in Micro-Scale Bending Processes

Improvement of process control in sheet metal forming by considering the gradual properties of the initial sheet metal

An application of fully coupled ductile damage model considering induced anisotropies on springback prediction of advanced high strength steel materials

An efficient closed-form solution for springback prediction and compensation in elastic–plastic creep age forming