Abstract:There are many typical symmetric large plastic deformation problems in aluminum alloy stamping. Warm stamping technology can improve the formability of materials and obtain parts with high-dimensional accuracy. Friction behavior in the stamping process is significant for the forming quality. An accurate friction coefficient is helpful in improving the prediction accuracy of forming defects. It is hard to obtain a unified and precise friction model through simple experiments due to the complicated contact conditions. To explore the effect of friction behavior on the forming quality, warm friction experiments of the AA6061 aluminum alloy and P20 steel with different process parameters were carried out using a high-temperature friction tester CFT-I (Equipment Type), including temperatures, the interface load, and sliding speeds. The variation curves of the friction coefficient with various parameters were obtained and analyzed. The results show that the friction coefficient increases with temperature and decreases with the sliding speed and load. Then, the influences of process parameters on the surface morphology of the samples after friction were observed by an optical microscope; adhesive wear occurred when the temperature increased, and the surface scratch increased and deepened with the increase in the load. Finally, the friction coefficient models of the speed and load were established by analyzing the data with Original software. Compared with the experimental and the finite element analysis results of the symmetrical part, the errors of the velocity friction model in thickness and springback angle are less than 4% and 5%, respectively. The mistakes of the load friction model are less than 6% and 7%, respectively. The accuracy of the two friction models is higher than that of the constant friction coefficient. Therefore, those coefficient models can effectively improve the simulation accuracy of finite element software.

Investigation on the effect of friction and material behavior models on the springback simulation precision: application to automotive part B-Pillar and material TRIP800 steel

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Finite element modeling for analyzing the production of high-strength steel sheets for automobile parts

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Characterisation and modelling of in-plane springback in a commercially pure titanium (CP-Ti)

A new predicting model study on U-shaped stamping springback behavior subjected to steady-state temperature field

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

Spring Back Behavior of Large Multi-Feature Thin-Walled Part in Rigid-Flexible Sequential Loading Forming Process

The prediction and control on the springback of the front inner panel of automobile at multi-steps stamping

Effects of Hardening Model and Variation of Elastic Modulus on Springback Prediction in Roll Forming

Springback Control in Complex Sheet-Metal Forming Based on Advanced High-Strength Steel

Friction and lubrication modelling in sheet metal forming: Influence of lubrication amount, tool roughness and sheet coating on product quality

Analysis of Sheet Metal Forming (Stamping Process): A Study of the Variable Friction Coefficient on 5052 Aluminum Alloy

Analytical prediction of springback based on residual differential strain during sheet metal bending

An application of fully coupled ductile damage model considering induced anisotropies on springback prediction of advanced high strength steel materials

An improved simplified model of self-piercing riveted joints for predicting quasi-static mechanical behavior of steel–aluminum hybrid components

Springback compensation for a vehicle’s steel body panel

Friction Characteristics Analysis of Symmetric Aluminum Alloy Parts in Warm Forming Process

Machine learning for extending capability of mechanical characterization to improve springback prediction of a quenching and partitioning steel

Description of elastic–plastic stress–strain transition in cyclic plasticity and its effect on springback prediction