Abstract:Robot-assisted incremental flanging (RAIF), a cost-effective and promising forming technology for producing large-size open-edge flanged parts in multi-variety and small batches, is expected to be widely used in aerospace, automotive and other technological industries. As a multi-pass incremental forming technique, the forming quality of the flanged parts is dependent on the movement of the roller controlled by the robot directly. The toolpath of a certain pass is determined by the rotation velocity (to adjust the flanging angle), the revolution velocity (to complete the flanging process of the whole blank sheet) and the matching relationship between two velocities (synchronously or asynchronously). In this paper, the process principle of RAIF technology is illustrated by using the example of shrink flanging firstly, then the effects of asynchronous motion and synchronous motion on the forming quality of a 60 degrees flanged part made of the 5A06 aluminum alloy are compared while the rotation and revolution velocity of the roller are set to 1 degrees/s and 1.8 degrees/s, respectively. Results show that the forming quality is improved significantly that the maximum height of edge waves is decreased from 2.1 mm to 0.19 mm when the roller is set to rotate and revolve synchronously. Based on the above comparison results, the rotation velocity is set as 1 degrees/s, 1.33 degrees/s, 2 degrees/s and 4 degrees/s respectively to further investigate the effect of different toolpaths on the forming quality under synchronous motion conditions. It can be found that the maximum stress gradually increases from 575.4 MPa to 621.6 MPa when the rotation velocity decreases from 4 degrees/s to 1 degrees/s.

Optimization on outer edge flanging path for 1060 aluminum sheet in two-pass incremental forming

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Dieless Double-Sided Incremental Hole-Flanging With Different Toolpath Strategies

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Research on Toolpath Optimization of Robot-Assisted Incremental Flanging

Reduction of Geometric Deviation by Multi-Pass Incremental Forming Combined with Tool Path Compensation for Non-Axisymmetric Aluminum Alloy Component with Stepped Feature

Investigation on A New Hole-Flanging Approach by Incremental Sheet Forming Through A Featured Tool

Experimental Investigations on Friction Stir Assisted Single Point Incremental Forming of Low-Ductility Aluminum Alloy Sheet for Higher Formability with Reasonable Surface Quality

Experimental investigations on the forming mechanism of a new incremental stretch-flanging strategy with a featured tool

Numerical simulation and experimental study on electromagnetic punching-flanging process of 6061 aluminum alloy sheets

Optimization of porthole extrusion die for 6063 aluminum alloy profile with thin-walled multi-cavity complex section and analysis of profile performance

Experimental and Finite Element Investigation of Over-Bending Phenomenon in Double-Sided Incremental Forming (DSIF) of Aluminium Sheets

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Optimization of Processing Parameters of Aluminum Alloy Cylindrical Parts Based on Response Surface Method during Hydromechanical Deep Drawing

Investigations on a Novel Double-Surface Single Point Incremental Forming Process for Sharp-Corner Features

Effective Forming Strategy for Double-Sided Incremental Forming Considering In-Plane Curvature and Tool Direction

Application of incremental forming in manufacturing of complicated thin-walled workpiece

A New Tool Path with Point Contact and Its Effect on Incremental Sheet Forming Process

An incremental flanging strategy for small hole with electropermanent magnetic device

Experimental Investigation on Friction-Stir-Assisted Incremental Forming with Synchronous Bonding of Aluminum Alloy and Steel Sheets

Improvement of circular hole flanging height using multi-directional electromagnetic flanging