Abstract:Cold bending forming is a complex forming process, and its product quality is closely related to the forming process parameters. To mitigate issues such as bulging and waviness arising from the extension of the material at the edges during the forming process of thin-walled circular tubes, a comprehensive comparative analysis was conducted on four forming methods. This analysis determined that the combined bending method is the optimal forming technique for the equipment. For the impact of different parameters on the equivalent plastic strain distribution of the product and the force on the rollers, numerical simulations were carried out using the software COPRA (COPRA FEA RF 2023.1) after designing the pattern diagram based on the integrated bending method. The results showed that different processing speeds on the equivalent plastic strain distribution and work hardening of the plate have little effect. As the spacing between the upper and lower rollers increases, the equivalent plastic strain of the plate to a certain extent and the value of the moment of the rollers is significantly reduced. Analyzing the performance characteristics of high-strength steel materials from the aspects of the thickness strain and cross-sectional forming of the plate, this verifies the advantages of forming high-strength steel plates. The numerical simulation results of this study are in good agreement with actual production experimental results.

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Whole process simulation of roll forming using dynamic explicit finite element method

Simulation of Roll Forming with Dynamic Explicit Finite Element Method

Numerical Simulation and Experimental of Forming Defects in Roll-Bending Process for Z-Shaped Profiles With Large Cross-Section

Simulation of a multi-stand roll-forming process for thick channel section

Numerical Simulation and Parameters Analysis for Roll Forming of Martensitic Steel MS980

Numerical Simulation and Parameter Optimization of Automobile Reinforced Inner Plate Forming Process

Simulation optimization and experimental verification of fracture during single point incremental forming process for sheet metal

3D Dynamic Simulation of Sheet Forming Process and Optimization of Process Parameters

Optimization Design of Roll Profiles for Cold Roll Forming Based on Response Surface Method

Numerical Simulation of Sheet Metal Digital Incremental Forming Process

The Simulation of Roll Forming with Multiple Passes

Numerical Simulation of Roll Forming for Channel Section with Outer Edge

Simulation of Multiple Cold Rolls Progressive Forming for Non-symmetrical Channel Section

Research on the Mechanism and Processability of Roll Forming

Numerical Simulation and Parameter Optimization for the Forming Process of Torque Box

FEM Analysis and Process Parameter Optimizing of High Speed Wire Rod During Reducing and Sizing Multi-Pass Groove Rolling Process

Optimization and Simulation of Machining Parameters in Radial-axial Ring Rolling Process.

Stress and Strain Analysis for Multiple Cold Rolls Progressive Forming of Channel Section with Outer Edge

Numerical Simulation on Optimization of Process Parameters for Free Bending of Metal Tubes