Abstract:This study presents a comprehensive investigation of fracture in open-stretched flanges formed using Single Point Incremental Forming (SPIF) on AA2024-T3 aluminium sheets. The work systematically explores the impact of geometric parameters, namely initial width and length, on the occurrence of the two primary failure modes: fracture at the corner and fracture at the edge of the flange. The experimental campaign comprises a series of flanging tests on medium-small radii to examine the deformation process on both the inner and outer surfaces of the flanges. The novelty of the investigation lies in two key aspects. Firstly, it offers, for the first time, an experimental characterisation of the onset of failure at the flange corner, which significantly limits the process's capabilities, and critically compares it with the failure at the flange edge. It is highlighted that the fracture at the corner is strongly influenced by tool-induced friction and the incremental nature of the SPIF process, resulting in a local formability significantly higher than expected with a quasi-proportional deformation process, as characterised by the conventional Fracture Forming Limit (FFL) evaluated through Nakazima tests. Secondly, a detailed formability analysis of the flange in the average stress triaxiality versus equivalent strain space is conducted, identifying a common region of Mode I fracture for plane stress applicable to both open-stretched flanges by SPIF and conventional Nakazima tests. To this end, an explicit numerical model based on the Barlat-89 anisotropic yield criterion is used to assess the non-proportional strain/stress paths, inherent in the incremental process. A numerical-experimental methodology is employed to predict both edge and corner failures of the flanges within the average stress triaxiality - equivalent strain space. The fracture loci for Mode I have been determined for both the incremental flanging tests and the Nakazima tests. A comparison of both fracture loci reveals a noticeably lower average stress triaxiality and larger equivalent strain in the SPIFed flanges than in the Nakazima tests, consistent with the increase in the apparent formability of the material observed experimentally in the incremental processes with respect to the conventional tests.

Investigation on A New Hole-Flanging Approach by Incremental Sheet Forming Through A Featured Tool

An incremental flanging strategy for small hole with electropermanent magnetic device

A new forming limit test method for incremental stretch flanging

Effect of pre-cut hole diameter on deformation mechanics in multi-stage incremental hole flanging of deep drawing quality steel

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Knowledge Based Design Support System for Complex Flanging Process Planning

Research on Sheet Metal Digital Incremental Forming Technology without Support

Geometric size and forming force prediction in incremental flanging: A new analytical model

Fracture in stretch flanging by single point incremental forming

Experimental Investigation on Friction-Stir-Assisted Incremental Forming with Synchronous Bonding of Aluminum Alloy and Steel Sheets

Experimental and numerical investigation of novel toolpaths on forming quality in DSIF

Toolpath strategy study for improving geometric accuracy of large-size open-edge flanged parts in robot-assisted incremental flanging

Improvement of circular hole flanging height using multi-directional electromagnetic flanging

A review on the deformation mechanism and formability enhancement strategies in incremental sheet forming

Modeling and analysis of multi-pass progressive flanging force of copper tube end

Numerical simulation and experimental study on electromagnetic punching-flanging process of 6061 aluminum alloy sheets

Investigation on mechanism in fabricating truncated cone with tooth features of titanium alloy via flexible free incremental forming at room temperature

Hole Flanging with Ironing of Two-Ply Thick Sheet Metals

Enhancing/Improving Forming Limit Curve and Fracture Height Predictions in the Single-Point Incremental Forming of Al1050 Sheet Material

Wall Thickness Uniformity in ISF of Hydraulic Support: System Design, Finite Element Analysis and Experimental Verification

Numerical Modelling for Efficient Analysis of Large Size Multi-Stage Incremental Sheet Forming