Abstract:Single point incremental forming (SPIF) is a new sheet metal forming process which achieves higher formability, greater process flexibility and reduced forming force compared to conventional sheet forming operations due to its characteristic of localized deformation. In recent years, a novel SPIF process assisted by localized friction heat is developed to further improve the material formability. Physically, the frictional heat is generated by the high relative motion at tool–workpiece interface resulted from tool rotation. However, the mechanisms behind formability difference induced by tool rotation at both low and high speed ranges are required to investigate in detail. In this paper, a series of experiments with an increase of tool rotation speeds ranging from 0 to 7000rpm are conducted to form AA5052-H32 aluminum alloy sheets into a truncated funnel. Additionally, the obtained results are analyzed in terms of formability, forming forces and temperature trends to find out the different roles of friction and heat during the forming process. As a result, the formability behaviors at varying tool rotation speeds can be categorized into four stages according to different reasons. It indicates that friction is the dominant factor in low tool rotation speed range (0–1000rpm) but will be substituted by thermal effect and potential dynamic recrystallization in high tool rotation speed range (2000–7000rpm). Furthermore, due to the proved lubrication enhancement and hydrodynamic enhancement generated by surface textures, a laser surface textured forming tool is also utilized to show its influence on forming forces, measured temperatures and the corresponding formability. Finally, it demonstrates that the fabricated laser surface texturing (LST) is capable to reduce the friction at tool–workpiece interface and change the magnitude of heat generation.

Experimental and numerical investigation of novel toolpaths on forming quality in DSIF

Experimental and Finite Element Investigation of Over-Bending Phenomenon in Double-Sided Incremental Forming (DSIF) of Aluminium Sheets

Investigation of Material Deformation Mechanism in Double Side Incremental Sheet Forming

Investigations on a Novel Double-Surface Single Point Incremental Forming Process for Sharp-Corner Features

Effective Forming Strategy for Double-Sided Incremental Forming Considering In-Plane Curvature and Tool Direction

Investigations on a novel quadratic spiral tool path and its effect on incremental sheet forming process

A New Tool Path with Point Contact and Its Effect on Incremental Sheet Forming Process

Multi-step Toolpath Approach of Improving the Dimensional Accuracy of a Non-Axisymmetric Part in Incremental Sheet Forming and Its Mechanism Analysis

Reduction of Geometric Deviation by Multi-Pass Incremental Forming Combined with Tool Path Compensation for Non-Axisymmetric Aluminum Alloy Component with Stepped Feature

Feature-based Tool Path Generation Approach for Incremental Sheet Forming Process

Investigations on the deformation mechanism of a novel three-sheet incremental forming

Improving the Accuracy of Double-Sided Incremental Forming Simulations by Considering Kinematic Hardening and Machine Compliance

General Contact Force Control Algorithm in Double-Sided Incremental Forming

Research on Sheet Metal Digital Incremental Forming Technology without Support

Research on the effects of machining paths and variable parameters of different passes on defects in multi-pass single-point incremental forming

Experimental and numerical investigation on surface quality for two-point incremental sheet forming with interpolator

Experimental investigations on the forming mechanism of a new incremental stretch-flanging strategy with a featured tool

Experimental Investigation on Friction-Stir-Assisted Incremental Forming with Synchronous Bonding of Aluminum Alloy and Steel Sheets

Investigation on A New Hole-Flanging Approach by Incremental Sheet Forming Through A Featured Tool

Geometric Deviation During Incremental Sheet Forming Process: Analytical Modeling and Experiment

Mechanism Investigation for the Influence of Tool Rotation and Laser Surface Texturing (LST) on Formability in Single Point Incremental Forming