Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Numerical Optimization of Asymmetric Surface Texturing under Reciprocating Sliding Conditions

Numerical Methods for Improving the Optimization Efficiency of Textured Surfaces

Improvement of Tribological Behaviors by Optimizing Concave Texture Shape Under Reciprocating Sliding Motion

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

Optimization of texture shape based on Genetic Algorithm under unidirectional sliding

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Optimization Tool Based on Multi-Objective Adaptive Surrogate Modeling for Surface Texture Design of Slipper Bearing in Axial Piston Pump

Evaluation and Optimization of Axial Piston Pump Textured Slipper Bearings with Spherical Dimples Based on Hybrid Genetic Algorithm

Asymmetric Surface Texturing for Directional Friction Control under Dry Sliding Condition

An Optimization Research on the Coverage of Micro-Textures Arranged on Bearing Sliders

Research Progress on the Design of Surface Texture in Tribological Applications: A Mini-Review

An Analytical And Experimental Parametric Study of Texturing In Slider Bearings Under Hydrodynamic/Mixed Lubrication

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Surface Tribological Properties Enhancement Using Multivariate Linear Regression Optimization of Surface Micro-Texture

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Research on Mixed Lubrication Problems of the Non-Gaussian Rough Textured Surface With the Influence of Stochastic Roughness in Consideration

Parametric Optimization of Circular Micro-pit Textures in Infinite Contact Area

Optimization of Boundary Slip Region on Bearing Sliders to Improve Tribological Performance

Optimal design of surface texture in meso scale air journal bearing