Abstract:Purpose This paper aims to propose an optimal design of the partial textures in the mixed lubrication regime of the crankpin bearing (CB) to maximize the CB's lubrication efficiency. Design/methodology/approach Based on a hybrid model between the slider-crank-mechanism dynamic and CB lubrication, the square-cylindrical textures (SCT) of partial textures designed on the CB’s mixed lubrication regime are researched. The effect of the density distributions of partial textures on CB’s lubrication efficiency is then evaluated via two indices of increasing the oil film pressure (p) and decreasing the frictional force ( F f ) of the CB. The SCT’s geometrical dimensions are then optimized by the genetic algorithm to further improve the CB’s lubrication efficiency. Findings The results show that the SCT of partial textures optimized by the genetic algorithm has an obvious effect on enhancing CB’s lubrication efficiency. Especially, with the CB using the optimal SCT of partial textures (4 × 6), the maximum p is significantly increased by 3.7% and 8.2%, concurrently, the maximum F f is evidently reduced by 9.5% and 21.6% in comparison with the SCT of partial textures (4 × 6) without optimization and the SCT of full textures (12 × 6) designed throughout the CB’s bearing surface, respectively. Originality/value The application of the optimal SCT of partial textures on the bearing surface not only is simple for the design-manufacturing process and maximizes CB’s lubrication efficiency but also can reduce the machining time, save cost and ensure the durability of the bearing compared to use the full textures designed throughout the CB’s bearing surface.

The optimization design for the journal-thrust couple bearing surface texture based on particle swarm algorithm

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Experimental investigation for vibration reduction of surface-textured journal bearings

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Optimal design of surface texture in meso scale air journal bearing

Optimization of twin grooved two-lobe textured hydrodynamic journal bearing design by using genetic algorithm

Effect of surface square textures on the physical field of static and dynamic pressure thrust bearings and multi-objective optimization

Texture Optimization and Verification for the Thrust Bearing Used in Rotary Compressors Based on a Transient Tribo-Dynamics Model

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Lubrication and stability analysis of nonlinear rotor-bearing system

Thermo-hydrodynamic analysis of large-eccentricity hydrodynamic bearings with texture on journal surface

Optimization of surface texture distribution on the thrust bearing using the mass-conserving cavitation boundary condition: Theory and experiments

Numerical simulation of the dynamic fluid–solid coupling in journal bearing with the effect of surface topography in consideration

Research on tribological performance of textured thrust bearing using gray relational degree and improved multi-objective water circulation algorithm

Transient lubrication analysis of journal-thrust coupled bearing considering time-varying loads and thermal-pressure coupled effect

Optimization Tool Based on Multi-Objective Adaptive Surrogate Modeling for Surface Texture Design of Slipper Bearing in Axial Piston Pump

Lubrication efficiency of crankpin bearing using square-cylindrical textures of partial textures optimized by genetic algorithm

Optimizing the Parameters of the Partial Textures of the Crankpin Bearing to Enhance the Lubrication Performance of an Engine

Optimization transient wear and contact performances of water-lubricated bearings under fluid-solid-thermal coupling condition using profile modification

Evaluation and Optimization of Axial Piston Pump Textured Slipper Bearings with Spherical Dimples Based on Hybrid Genetic Algorithm

Optimization of Groove Texture Profile to Improve Hydrodynamic Lubrication Performance: Theory and Experiments