Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Effect of optimal rapid thermal alloying of ohmic contacts to microwave pseudomorphic HEMTs

Investigation on Thermo-Mechanical Responses in High Power Multi-Finger AlGaN/GaN HEMTs

A New Meshing Criterion for the Equivalent Thermal Analysis of GaAs PHEMT MMICs.

Equivalent method of GaAs PHEMT MMIC for thermal simulation

Mechanism of Ohmic Contact Formation in AlGaN/GaN High Electron Mobility Transistors Using Microwave Annealing

Experimental insight into the temperature effects on DC and microwave characteristics for a GaAs pHEMT in multilayer 3‐D MMIC technology

Study of Self-Heating and High-Power Microwave Effects for Enhancement-Mode p-Gate GaN HEMT

Mechanism of AlGaAs/InGaAs pHEMT Nonlinear Response Under High-Power Microwave Radiation

A Temperature Analysis of High-power AlGaN/GaN HEMTs

Low-Temperature Ohmic Contact Formation in AlN/GaN HEMT Using Microwave Annealing

Comparative Study of Si3N4-PECVD and Al2O3-ALD Surface Passivation in T-Shaped Gate InAlAs/InGaAs InP Based HEMTs

Si-implantation for Low Ohmic Contact Resistances in RF GaN HEMTs

Electrical properties of metamorphic In<sub>0.52</sub>Al<sub>0.48</sub>As/In<sub>0.65</sub>Ga<sub>0.35</sub>As HEMT's on GaAs substrate

Electrical properties of metamorphic in0.52Al 0.48As/In0.65Ga0.35As HEMT's on GaAs substrate

Enhanced Device Performance Of Algan/Gan High Electron Mobility Transistors With Thermal Oxidation Treatment

Effect of High Temperature on the Performance of AlGaN/GaN T-Gate High-Electron Mobility Transistors With ~140-nm Gate Length

AlGaN/GaN HEMTs with thermal oxidation treatment for microwave power applications

Low Leakage Current and High-Cutoff Frequency AlGaN/GaN MOSHEMT Using Submicrometer-Footprint Thermal Oxidized TiO2/NiO As Gate Dielectric

Electro-Thermal Co-Optimization Design of GaN MMIC PA

Impact of Mg out-diffusion and activation on the p-GaN gate HEMT device performance

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer