Abstract:Abstract. Background To keep up with the logic area scaling, back-end-of-line (BEOL) structures are reduced to smaller pitches, requiring faster and reliable metrology and defect detection solution. Aim Metrology and detailed defect inspection at the early phases of process optimization. Approach Single exposure (SE) 0.33NA extreme ultraviolet (EUV) lithography was used along with a bright field mask for patterning in a metal damascene process flow of BEOL structures. We also used a dual damascene process flow for voltage contrast (VC) metrology study. Results Scatterometry technique, together with machine learning (ML), allowed us to have fast and accurate measurements of line-space (LS) and tip-to-tip (T2T) critical dimension (CD), and prediction of electrical performance. We demonstrated characterization results of stochastic defects across various test structures of 28-nm pitch devices. We used a large-area electron beam (e-beam) tool for high-speed large-area inspection which provided us with the quick feedback on defect signatures and scope for further root cause analysis. On a separate dual damascene integration flow, we used VC metrology to capture different failure modes in the patterning process of metal trenches with tight T2T and corresponding overlapping vias. Conclusions We studied the impact of stochastic resist defects on electrical measurements of meander (MR) and fork-fork (FF) structures, and showed that large electrical test structures, built with a relatively simple patterning flow, can be used at the early stages of resist and patterning development, as the electrical failures are almost exclusively caused by the resist defects. In the dual damascene flow, we demonstrated that VC metrology is useful to determine the design rule parameters and capture different failure mechanisms.

Measurement and Calculation Method for Sub-20 Nm Line and DSA Patterns

Analysis of Linewidth Uniformity and Line Edge/Width Roughness in a 5 Nm Logic SAQP Process

Canny Algorithm Enabling Precise Offline Line Edge Roughness Acquisition in High-Resolution Lithography.

Alignment Methods for Micron-Scale Surface Defects Automatic Evaluation of Large-Aperture Fine Optics

Optimizing Sub-resolution Assist Features Using Test Pattern Method

Automatic Measurement of Silicon Lattice Spacings in High-Resolution Transmission Electron Microscopy Images Through 2D Discrete Fourier Transform and Inverse Discrete Fourier Transform

Sidewall angle calculation on CD-SEM metrology

Full-flow surface defect identification method based on spot scanning scattering for unpatterned wafer

Deep learning denoiser assisted roughness measurements extraction from thin resists with low Signal-to-Noise Ratio(SNR) SEM images: analysis with SMILE

A strategy to fabricate nanostructures with sub-nanometer line edge roughness

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Overlay Metrology for Lithography Machine

Diagnosing and removing CD-SEM metrology artifacts

Photoresist Process Simulation to Study Line Edge Roughness

Development of 90 NM & 5 NM High Resolution Advanced Lithographic Patterning Materials

Investigations on the Correlation Between Line-Edge-roughness (LER) and Line-Width-roughness (LWR) in Nanoscale CMOS Technology

Investigations on Line-Edge Roughness (LER) and Line-Width Roughness (LWR) in Nanoscale CMOS Technology: Part I–Modeling and Simulation Method

Process Optimization of Line Patterns in Extreme Ultraviolet Lithography Using Machine Learning and a Simulated Annealing Algorithm.

Quantitative evaluation of residual resist in electron beam lithography based on scanning electron microscopy imaging and thresholding segmentation algorithm

Investigating metal oxide resists for patterning 28-nm pitch structures using single exposure extreme ultraviolet: defectivity, electrical test, and voltage contrast study

New Method for BEOL Overlay and Process Margin Characterization