Abstract:Although <math>{101¯2}</math> twinning behavior has been extensively studied, it has rarely been investigated under biaxial tension. In the present research, the mechanical response and <math>{101¯2}</math> twinning behavior of a Mg AZ31 sheet under biaxial tension with various stress ratios (<math>σND:σTD</math>) along the normal direction (ND) and transverse direction (TD) were systematically studied. The results indicate that the yield stress along the ND is nearly independent of <math>σND:σTD</math>. Schmid law applied to <math>{101¯2}</math> twinning under biaxial tension yields better efficiency than that for uniaxial tension, and a higher efficiency is observed with a larger stress ratio along the TD; the fraction of experimentally observed twin variants with Schmid factors (SFs) of ranks 1 and 2 is approximately 45% for uniaxial tension, whereas it is approximately 68% for <math>σND:σTD=2:1</math> and approximately 88% for <math>σND:σTD=1:2</math>. This result contradicts with the previously reported result that Schmid law is more efficient for uniaxial stress states than under multiaxial stress conditions. It is found that biaxial tension will increase the difference in SF for the six twin variants and make Schmid law more efficient. Twin variant selection and volume fraction are highly dependent on <math>σND:σTD</math>. For uniaxial tension, the activities for the six variants are similar, and the (0002) poles of the twins are distributed evenly on a circle approximately 80°–90° away from the ND. In contrast, the variants <math>(01¯12)[011¯1]</math> and <math>(011¯2)[01¯11]</math> are more favorable under biaxial tension, and more (0002) poles of the twins concentrate around the rolling direction with a higher ratio of <math>σTD</math>. At a similar strain level, the twin fraction under biaxial tension is often different from that under uniaxial tension, and this difference varies with <math>σND:σTD</math>. This mechanism is associated with a stress-ratio-mediated detwinning behavior under biaxial tension. The findings in the present study provide a new and significant understanding of the twinning behavior of Mg alloys.

On the Modeling of Deformation Mechanisms in a Mg-3Al-1Zn Alloy under Biaxial Tension

Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure

Experimental and Numerical Investigation of Anisotropic and Twinning Behavior in Mg Alloy under Uniaxial Tension

Strain-Path Dependence of { 101̅2} Twinning in a Rolled Mg–3Al–1Zn Alloy: Influence of Twinning Model

Strain-Path Dependence of $$ \{ 10\bar{1}2\} $$ Twinning in a Rolled Mg–3Al–1Zn Alloy: Influence of Twinning Model

Crystal Anisotropy of AZ31 Magnesium Alloy under Uniaxial Tension and Compression

{ 10 1 ̄ 2 } twinning behavior under biaxial tension of Mg–3Al–1Zn plate

Numerical simulation of plastic behavior and meso inhomogeneous deformation in AZ31 Mg alloy

{101¯2} Twinning Behavior under Biaxial Tension of Mg–3Al–1Zn Plate

Biaxial Deformation Behavior of AZ31 Magnesium Alloy along RD and Diagonal Direction Degree Between TD and ND

Modeling the Deformation Behavior of A Rolled Mg Alloy with the Evpsc-Tdt Model

Mechanical Anisotropy Induced by the Competition Between Twinning and Basal Slip of AZ31 Magnesium Alloy under Biaxial Tension

Relationship Between Textures and Deformation Modes in Mg–3Al–1Zn Alloy During Uniaxial Tension

On twinning and anisotropy in rolled Mg alloy AZ31 under uniaxial tension

Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation

Deformation Dynamics in Pre-Twinned Mg-3Al-1Zn Alloy: A Synchrotron X-ray Study

Study of Twinning Behavior of Az31 Mg Alloy During Plane Strain Compression

A quantitative study on mechanical behavior of Mg alloys with bimodal texture components

Twinning and Mechanical Behavior of an Extruded Mg–6Al–3Sn Alloy with a Dual Basal Texture

Role of {101‾2} Twinning in the Anisotropy and Asymmetry of AZ31 Magnesium Alloy under High Strain Rate Deformation

Twinning–Detwinning-Dominated Cyclic Deformation Behavior of a High-Strength Mg-Al-Sn-Zn Alloy during Loading Reversals: Experiment and Modeling