Abstract:Although <math>{101¯2}</math> twinning behavior has been extensively studied, it has rarely been investigated under biaxial tension. In the present research, the mechanical response and <math>{101¯2}</math> twinning behavior of a Mg AZ31 sheet under biaxial tension with various stress ratios (<math>σND:σTD</math>) along the normal direction (ND) and transverse direction (TD) were systematically studied. The results indicate that the yield stress along the ND is nearly independent of <math>σND:σTD</math>. Schmid law applied to <math>{101¯2}</math> twinning under biaxial tension yields better efficiency than that for uniaxial tension, and a higher efficiency is observed with a larger stress ratio along the TD; the fraction of experimentally observed twin variants with Schmid factors (SFs) of ranks 1 and 2 is approximately 45% for uniaxial tension, whereas it is approximately 68% for <math>σND:σTD=2:1</math> and approximately 88% for <math>σND:σTD=1:2</math>. This result contradicts with the previously reported result that Schmid law is more efficient for uniaxial stress states than under multiaxial stress conditions. It is found that biaxial tension will increase the difference in SF for the six twin variants and make Schmid law more efficient. Twin variant selection and volume fraction are highly dependent on <math>σND:σTD</math>. For uniaxial tension, the activities for the six variants are similar, and the (0002) poles of the twins are distributed evenly on a circle approximately 80°–90° away from the ND. In contrast, the variants <math>(01¯12)[011¯1]</math> and <math>(011¯2)[01¯11]</math> are more favorable under biaxial tension, and more (0002) poles of the twins concentrate around the rolling direction with a higher ratio of <math>σTD</math>. At a similar strain level, the twin fraction under biaxial tension is often different from that under uniaxial tension, and this difference varies with <math>σND:σTD</math>. This mechanism is associated with a stress-ratio-mediated detwinning behavior under biaxial tension. The findings in the present study provide a new and significant understanding of the twinning behavior of Mg alloys.

A quantitative study on mechanical behavior of Mg alloys with bimodal texture components

Twinning and Mechanical Behavior of an Extruded Mg–6Al–3Sn Alloy with a Dual Basal Texture

Tensile mechanical behavior and texture evolution of the weak texture Mg–1Al–0.5Mn–0.3Gd magnesium alloy

Numerical simulation of plastic behavior and meso inhomogeneous deformation in AZ31 Mg alloy

Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation

On the Modeling of Deformation Mechanisms in a Mg-3Al-1Zn Alloy under Biaxial Tension

Effects of Bimodal Basal Texture on Bending Stress and Microstructure Evolution of Mg-2.6Nd-0.55Zn-0.5Zr Alloys

Experimental and Numerical Investigation of Anisotropic and Twinning Behavior in Mg Alloy under Uniaxial Tension

The Texture Dependence of Strength in Slip and Twinning Predominant Deformations of Mg-3Al-1Zn Alloy

Twinning Characteristic in Tension of Magnesium Alloys and Its Effect on Mechanical Properties

Micromechanics Modeling on Mechanical Properties in Mg Alloys with Bimodal Grain Size Distribution

Microstructure and Texture Evolution of AZ31 Mg Alloy Processed by Multi-Pass Compressing under Room Temperature

Effects of texture and twinning on the torsional behavior of magnesium alloy solid rod: A crystal plasticity approach in comparison with uniaxial tension/compression

Relationship Between Textures and Deformation Modes in Mg–3Al–1Zn Alloy During Uniaxial Tension

Strain-Path Dependence of { 101̅2} Twinning in a Rolled Mg–3Al–1Zn Alloy: Influence of Twinning Model

Ductility Improvement by Twinning and Twin–slip Interaction in a Mg-Y Alloy

Mechanical Anisotropy Induced by the Competition Between Twinning and Basal Slip of AZ31 Magnesium Alloy under Biaxial Tension

Unveiling the Twinning and Dynamic Recrystallization Behavior and the Resultant Texture Evolution in the Extruded Mg-Bi Binary Alloys During Hot Compression

{ 10 1 ̄ 2 } twinning behavior under biaxial tension of Mg–3Al–1Zn plate

Enhancement of the Mechanical Properties of Textured AZ31 Mg Alloy Sheets by Bimodal-Orientation Microstructure: Basal Orientation and RD-texture

Three-dimensional study of grain scale tensile twinning activity in Mg: A combination of microstructure characterization and mechanical modeling