Abstract:The mechanical and twinning behavior of Mg alloys containing a monolithic texture component have been extensively studied; however, studies on samples with multi texture components are much insufficient. In this study, the quantitative relationship between the mechanical behavior under tension along the extrusion direction (ED) of Mg AZ31 rods and the percentages of bimodal texture components <0002>// ED (19–87%) and <0002>⊥ED were systematically studied. The component <0002>// ED favors <math>{101¯2}</math> twinning and is soft orientations; however, the component <0002>⊥ED favors prismatic slip and is hard orientations. The results show that the yield strength does not decrease linearly with an increase in the percentage of the soft orientations and show a deviation from the calculations using the conventional rule of mixtures. A higher percentage of the soft grains increases this deviation when the percentage is below 50%, and decreases it over 50%. The ultimate strengths, however, do not show an obvious dependence on the percentage of the soft orientations. Subsequently, the corresponding mechanisms are discussed and a modified rule of mixtures was developed. Bimodal texture components stimulate the activation of <math>{101¯2}</math> twin variants with a low Schmid factor and the presence of more variants within one grain. Conventional strain accommodation rule was used to analyze this twinning behavior, but it cannot explain the experimental observations. Crystal-plasticity based finite element modeling was employed to analyze this strange twinning behavior. The results indicate that the interaction among twin variants, rather than deformation in neighboring grains, plays a major role in the activation of twins with a low Schmid factor, due to a hard deformation propagation from the soft grains to the hard grains. This finding provides an important complementation to the strain accommodation theory.

Tensile mechanical behavior and texture evolution of the weak texture Mg–1Al–0.5Mn–0.3Gd magnesium alloy

Effects of Deformation Mechanisms on Texture Evolution and Mechanical Response of the Mg-1Al-0.5Mn-0.3Gd Alloy Under Plane Tension

A quantitative study on mechanical behavior of Mg alloys with bimodal texture components

Achieving High Ductility and Low In-Plane Anisotropy in Magnesium Alloy Through a Novel Texture Design Strategy

Understanding the weakening of texture in multiaxial forged ultrafine-grained strong and ductile Mg-2Zn-2Gd alloy

Texture property and weakening mechanism of Mg-3Al-1Zn alloy by interactive alternating forward extrusion

Texture and Texture Optimization of Wrought Mg Alloy

Study on Deformation Behavior of High Ductility Mg-2Gd-0.5Mn Alloy During Tensile Process

The texture and its optimization in magnesium alloy

Deformation Behavior and Texture Evolution in an Extruded Mg-Li Sheet with Non-Basal Texture During Tensile Deformation

Investigation of the Alloying Effect on Deformation Behavior in Mg by Visco-Plastic Self-Consistent Modeling

Twinning and Mechanical Behavior of an Extruded Mg–6Al–3Sn Alloy with a Dual Basal Texture

Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation

Effects of Bimodal Basal Texture on Bending Stress and Microstructure Evolution of Mg-2.6Nd-0.55Zn-0.5Zr Alloys

Texture Evolution and Their Effects on the Mechanical Properties of Duplex Mg–Li Alloy

Twinning-Assisted Static Recrystallization and Texture Evolution in A Mg-Gd-Y-Zr Alloy

Deformation behavior of Mg-8.5wt.%Al alloy under reverse loading investigated by in-situ neutron diffraction and elastic viscoplastic self-consistent modeling

Texture Adjustment Approach of Magnesium Alloys Via Variable Strain Path Calculated by an Integrated Finite Element-Viscoplastic Self-Consistent Model

Texture control by {10-12} twinning to improve the formability of Mg alloys: A review

Adjusting Approaches of Basal Texture for Improvement of Tension-Compression Asymmetry in Extruded Magnesium Alloys

Texture weakening effect from { 10 1 ̅ 1 } twins induced static recrystallization in ambient extrusion AZ31 magnesium alloy