Twinning–Detwinning-Dominated Cyclic Deformation Behavior of a High-Strength Mg-Al-Sn-Zn Alloy during Loading Reversals: Experiment and Modeling

Huai Wang,Yongze Yu,Binjiang Lv,Ming Song,Xuefang Xie

DOI: https://doi.org/10.3390/met14060635

IF: 2.695

2024-05-28

Metals

Abstract:The deformation behavior of a high-strength Mg-Al-Sn-Zn alloy under loading reversals has been thoroughly examined through a combination of experimental measurements and crystal plasticity modeling. We focused on an age-treated alloy fortified by distributed Mg2Sn particles and Mg17Al12 precipitates, which underwent two distinct loading cycles: tension-compression-tension (TCT) and compression-tension-compression (CTC), aligned with the extrusion direction (ED). The initial and deformed microstructures of the alloy were analyzed using the electron backscattering diffraction (EBSD) technique. Notably, the alloy displays tensile and compressive yield strengths (YS) of 215 MPa and 160 MPa, respectively, with pronounced anelastic behavior observed during unloading and reverse loading phases. Utilizing the elasto-viscoplastic self-consistent model incorporating a twinning–detwinning scheme (EVPSC-TDT), the cyclic stress–strain responses and resultant textures of the alloy were accurately captured. The predicted alternation between various slip and twinning modes during plastic deformation was used to interpret the observed behaviors. It was found that prismatic slip plays an important role during the plastic deformation of the studied alloy, and its relative activity in tensile loading processes accounts for up to ~66% and ~67% in the TCT and CTC cases, respectively. Moreover, it was discerned that detwinning and twinning behaviors are predominantly governed by stresses within the parent grain, and they can concurrently manifest during the reverse tensile loading phase in the TCT case. After cyclic deformation, the area fractions of residual twins were determined to be 7.51% and 0.93% in the TCT and CTC cases, respectively, which is a result of the varied twinning–detwinning behavior of the alloy in different loading paths.

materials science, multidisciplinary,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the deformation behavior mechanism of magnesium - aluminum alloy during cyclic loading reversal. Specifically, the researchers are concerned with the deformation behavior of high - strength Mg - Al - Sn - Zn alloy when it undergoes load - unload - reverse load cycles, especially the influence of twinning - detwinning behavior on the material properties. By combining experimental measurement and crystal plasticity modeling, the researchers aim to clarify the deformation mechanisms of this alloy under different loading path changes, including the alternating dominant roles of various slip modes and twinning modes, twinning - detwinning behavior and the evolution of crystallographic texture.

The paper mentions that although previous studies have explored the influence of the alloying effect of the newly developed Mg - Al - Sn - Zn alloy on its mechanical properties, most of the studies are limited to the deformation behavior under uniaxial loading conditions, and less attention has been paid to the deformation mechanism when the loading path changes. Therefore, the main objective of this study is to reveal the deformation mechanisms of Mg - Al - Sn - Zn alloy during loading, unloading and reverse loading by combining experimental measurement and crystal plasticity modeling.