An Application of a Cavity-Based Beam Arrival Time Measurement System: Beam Energy Measurement

Shanshan Cao,Yongbin Leng,Renxian Yuan,Jian Chen

DOI: https://doi.org/10.1016/j.nima.2022.167456

IF: 1.335

2022-01-01

Nuclear Instruments and Methods in Physics Research Section A Accelerators Spectrometers Detectors and Associated Equipment

Abstract:A high-resolution cavity-based beam arrival/flight time measurement system has been established at SXFEL (Shanghai soft X-ray free-electron laser facility). During the development of the system, a correlation between the energy jitter and the beam flight time jitter was found which inspires and motivates us to further explore the possibility of using the beam arrival/flight time measurement system to measure the beam energy. On the one hand, beam energy is one of the most fundamental and critical parameters for accelerator facilities. Only precise handling of the beam energy enables precise control of the FEL (free-electron laser) radiation wavelength. On the other hand, there are only a few methods for beam energy measurement. The profile -based beam energy measurement method is commonly used but is interceptive. The BPM-based beam energy measurement scheme is non-interceptive but has a limited dynamic range and requires initial beam position calibration. This paper reports a promising application of a cavity-based high-resolution beam arrival/flight time measurement system: non-intercepting wide-range beam energy measurement. A brief introduction of the method principle and system implementation has been covered in this article. Moreover, a beam-based preliminary test has been performed and the test results show a linear correlation between the beam energy and the beam flight time under the current system configuration. The measured linear factor is 0.692 ps/MeV. In addition, the relative bunch energy measurement resolution is 0.0001.