Abstract:The laser hot-wire (LHW) process has the potential to deposit material at high rates using low laser power. An LHW experiment was designed to be able to deposit material at the rate of 3.46 kg per hour with less than 10 kW of laser power. Four thermocouples were built into the substrate to record the temperature variation during the deposition. The results show that temperature fluctuates in a periodic manner with the deposition layer by layer. Simultaneously, the distortion of the substrate was measured. The substrate is distorted, and the maximum distortion increases gradually during deposition.The equivalent heat conduction coefficient for heat convection in the molten pool is discussed. It becomes apparent that the heat convection of flowing molten metal is 3-5 times that of molten metal at rest. The absorptivity of laser power was determined by comparison between the simulation and a one-pass cladding experiment. The absorptivity of laser power is approximately 15% in this experiment.Numerical simulation of LHW additive manufacturing was conducted to obtain the temperature, stress and strain fields, and the distortion. The outstanding features for numerical simulation are additive geometry and numerous analysis steps. The INP files of ABAQUS are compiled in a Matlab program because of the considerable number of steps and element definitions. Temperature variation and substrate distortion are both measured to validate the FEA model. The verification result indicates that the LHW model is feasible and accurate.The maximum residual stress is located in the junction between the deposit and substrate when the deposition is finished. This junction area becomes the most likely crack position. Deposited material undergoes complicated thermal cycles during the LHW process. Temperature variation determines the phase transformation. The microstructure change of the heat affected zone was analyzed on the basis of computational temperature variation. Such interpretation can effectively explain softened area in the heat affected zone of the substrate. A numerical computation method is used to map the processing window of stable hot-wire deposition. It is shown that the stable deposition has top and bottom limitations under a certain current intensity and wire feed speed. (C) 2016 Elsevier B.V. All rights reserved.

Model Heat Source Using Actual Distribution of Laser Power Density for Simulation of Laser Processing

New Heat Source Model for Accurate Estimation of Laser Energy Absorption Near Free Surface in Selective Laser Melting

Three-Dimensional Transient Simulation of Laser Deep-penetration Welding Based on Combined Heat Source

A new heat source model for selective laser melting simulations based on energy distribution on the powder layer and the surface of substrate

Heat Source Model Development for Thermal Analysis of Laser Powder Bed Fusion Using Bayesian Optimization and Machine Learning

Analytical modeling of workpiece temperature in laser-assisted milling considering the combined effect of multi-heat sources

An analytical model of energy distribution in laser direct metal deposition

Temperature Field Simulation of Laser Transmission Welding PA66 Based on Volumetric Heat Source

Correlating Laser Additive Manufacturing Process with Heat Source Coefficients by Integrated Experimental and Numerical Models

Discrepancies between Gaussian surface heat source model and ray tracing heat source model for numerical simulation of selective laser melting

A Physically Motivated Heat Source Model for Laser Beam Welding

Heat source models for numerical simulation of laser welding processes – a short review

Modeling of Temperature Field Evolution During Multilayered Direct Laser Metal Deposition

Mathematical model of laser material processing

On the importance of heat source model determination for numerical modeling of selective laser melting of IN625

A Gaussian Process-Based extended Goldak heat source model for finite element simulation of laser powder bed fusion additive manufacturing process

A New Heat Transfer Simulation Model for Selective Laser Melting to Estimate the Geometry of Cross Section of Melt Pool

Modeling of Temperature Field and Pool Formation During Linear Laser Welding of DP1000 Steel

Experimental Study and Modeling of H13 Steel Deposition Using Laser Hot-Wire Additive Manufacturing

Heat Source Models in Numerical Simulations of Laser Welding

Multiscale Modeling of Electron Beam and Substrate Interaction: a New Heat Source Model