Abstract:This work reports in first time a 100-Gb/s, ultra-low noise, variable gain multi-stagger tuned transimpedance amplifier (VGMST-TIA) over the D-band performance. The whole work is binding into two phases. The first phase involves the modeling and characterization of graphene field-effect transistor (GFET) with an optimized transition frequency of operation. While in the second phase, a TIA design employs a T-shaped symmetrical L-R network at the input, which mitigates the effect of photo diode capacitance and achieves a D-band of operation. The proposed work uses a VGMST to establish TIA, which realizes optimum noise performance. The high gain 3-stage VGMST-TIA effectively minimizes the white noise and illustrates a sharp out-of-band roll-off to achieve considerable noise reduction at high frequencies. The active feedback mechanism controls the transimpedance gain by tuning the control voltage which results better group delay. Besides, an L-C circuit is employed at the output to enhance bandwidth. The full TIA is implemented and fabricated using a commercial nano-manufacturing 9-nm graphene film FET on a silicon wafer using 0.065-μm process. The TIA achieves a flat transimpedance gain of 61.2 dBΩ with ± 9 ps group delay variation over the entire bandwidth. The proposed TIA measured an impedance bandwidth of 0.2 THz with ultra-low input-referred noise current density of 2.03 pA/√Hz. The TIA supports a 100-Gb/s data transmission due to large bandwidth; therefore, a bit-error-rate (BER) less than 10<sup>−12</sup> is achieved. The chip occupies an area of 0.92 * 1.34 mm<sup>2</sup> while consuming power of 21 mW under supply of 1.8 V.

A 50mhz Bandwidth TIA Based on Two Stage Pseudo-Differential OTA with Cascode Negative Resistance and R-C Compensation Technique

A 29.5 Dbm OOB IIP3 TIA Based on a Two-Stage Pseudo-Differential OTA with R-C Compensation and Cascode Negative Resistance

A 50-MHz Bandwidth and 50.6-dBm OOB-IIP3 Transimpedance Amplifier Based on a Three-Stage Pseudo-Differential OTA

Design of a 50mhz Bandwidth TIA Using Negative Capacitance

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

High gain, high speed OTA for S/H circuit in 14-b 100-MS/s Pipeline ADC

An Inductorless 5-GHz Differential Dual Regulated Cross-Cascode Transimpedance Amplifier using 40 nm CMOS

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

A Single-to-differential Broadband Transimpedance Amplifier for 12.5 Gb/s Optical Links.

Low-Noise Broadband CMOS TIA Based on Multi-Stage Stagger-Tuned Amplifier for High-Speed High-Sensitivity Optical Communication.

A Design Methodology to Extend Bandwidth for Regulated Cascode Transimpedance Amplifier.

High-Gain and Wide Bandwidth Gain-Boosting OTA

Signal Integrity Augmentation Techniques for the Design of 64-Gbaud Coherent Transimpedance Amplifier in 90-Nm SiGe BiCMOS

A 44gbit/s Wide-Dynamic Range and High-Linearity Transimpedance Amplifier in 130nm BiCMOS Technology

10 Gb/S 1.95 Mw Active Cascode Transimpedance Amplifier for High Speed Optical Receivers

A 20-Gb/s CMOS Cross-Coupled Dual-Feedback Loop Transimpedance Amplifier

Wide-Band Inductorless and Capacitorless LNTA Based on Cascode Inverters

Area-efficient CMOS transimpedance amplifier for optical receivers

A 224-Gb/s Inverter-Based TIA with Interleaved Active-Feedback and Distributed Peaking in 28-Nm CMOS for Silicon Photonic Receivers

A 61.2-dBΩ, 100 Gb/s Ultra-Low Noise Graphene TIA over D-Band Performance for 5G Optical Front-End Receiver

A 85-Gb/s PAM-4 TIA with 2.2-Mapp Maximum Linear Input Current in 28-Nm CMOS