Abstract:The increase of carrier frequency enables the utilization of the abundant high-frequency resource to meet the ceaseless demand for high data-rates. With respect to the transmitter, the design challenges include linear and high-efficiency PAs at high frequencies, low out-of-band (OOB) noise for frequency division duplex (FDD) applications, etc. Moreover, the integration of PAs on the CMOS die with other transmitter blocks greatly reduces the form factor and cuts down the cost. Among various linearization techniques, the Cartesian feedback architecture excels in its robustness against the process, voltage and temperature (PVT) variations as well as aging effects, but suffers from the noise-linearity trade-off caused by the feedback path [1]–[3]. To mitigate this issue, a Cartesian error-feedback architecture is proposed by adopting a reference path to cancel the signal before the feedback path and only leave the error information in principle. In this work, an $X -$band Cartesian error-feedback transmitter with a fully integrated power amplifier in bulk CMOS is implemented, and delivers maximum power $( \mathrm {P}_{SAT})$of 21.4dBm and output-referred 1dB compression point (OP $_{1dB})$of 21dBm. At $\mathrm {P}_{SAT}$and OP $_{1dB}$, the PA efficiency reaches 33.3% and 30.3%, with total system efficiency of 22.3% and 20.3%, respectively. Compared with the open-loop condition, the closed-loop transmitter demonstrates up to 13.6dB suppression of ACLR using WCDMA uplink (UL) signals, and improves EVM by over 6dB for 4Ms/s 64-QAM signals and over 3dB up to 16Ms/s signals. The out-of-band noise at 100MHz is -133/-131.8dBm/Hz for the lower and upper sidebands respectively.

A 20-Gb/s CMOS Cross-Coupled Dual-Feedback Loop Transimpedance Amplifier

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

An Inductorless 5-GHz Differential Dual Regulated Cross-Cascode Transimpedance Amplifier using 40 nm CMOS

Area-efficient CMOS transimpedance amplifier for optical receivers

A 12.5 Gb/s 1.38 mW all-inverter-based optical receiver with multi-stage feedback TIA and continuous-time linear equalizer

200 Gb/s Optical-Amplifier-Free IM/DD Transmissions Using a Directly Modulated O-Band DFB+R Laser Targeting LR Applications

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A Hybrid Integrated TIA and PD for 20-Gb/s Optical Receivers

A Linear Differential Transimpedance Amplifier for 100-Gb/s Integrated Coherent Optical Fiber Receivers

An Area-Efficient and Programmable 4 x 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 m SiGe BiCMOS

CMOS 1.4 THzΩ 155 Mb/s differential transimpedance preamplifier for optical receiver

An Area-Efficient and Programmable 4 × 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 µm SiGe BiCMOS

A 4 X 56-Gbaud PAM-4 Optical Receiver Integrated with SiGe-BiCMOS TIA

A Low-Noise 56gbps Pam-4 Linear Optical Receiver In 40nm Cmos

A 29.5 Dbm OOB IIP3 TIA Based on a Two-Stage Pseudo-Differential OTA with R-C Compensation and Cascode Negative Resistance

Design and Analysis of 20 Gb/s Inductorless Limiting Amplifier in 65 Nm CMOS Technology

A 56-GBaud Linear Optical Receiver Hybrid Integrated with InGaAs PIN PDs

A 50mhz Bandwidth TIA Based on Two Stage Pseudo-Differential OTA with Cascode Negative Resistance and R-C Compensation Technique