Abstract:A 50 MHz bandwidth (BW) transimpedance ampli-fier (TIA) is designed for 5G Sub-6GHz SAW-less current-mode receivers (RX). It's based on an operational transconductance amplifier (OTA). To tolerate blockers, the TIA must exhibit excellent in-band (IB) and out-of-band (OOB) linearity, which in turn requires OTAs with high BW and gain. Traditional two-stage OTAs struggle to achieve this under low power consumption (PC), so this paper employs a three-stage OTA. A pseudo-differential structure without the tail current source is used to accommodate low supply voltages (Vdd). Differential-mode (DM) stability relies on feedforward (FF) compensation within the OTA and zero compensation in the feedback network. Common mode (CM) is stabilized by five different common mode rejection (CMR) techniques. The circuit is designed and simulated in a 40 nm low power (LP) CMOS technology with a Vdd of 1.2V. The post-layout simulation results show that when IM3 is set to 30 MHz, the TIA's IB and OOB IIP3 reach 31.6 dBm and 50.6 dBm, respectively. The minimum input-referred noise (IRN) is 5.14 <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">$\mathbf{nV}/\sqrt{Hz}$</tex> . The corresponding FoM value is as high as 186.3 dBJ- <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1</sup> , exceeding all previous designs. The chip consumes 10.4 mW of power and occupies only 0.016mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> .

Area-efficient CMOS transimpedance amplifier for optical receivers

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

A 20-Gb/s CMOS Cross-Coupled Dual-Feedback Loop Transimpedance Amplifier

An Inductorless 5-GHz Differential Dual Regulated Cross-Cascode Transimpedance Amplifier using 40 nm CMOS

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 29.5 Dbm OOB IIP3 TIA Based on a Two-Stage Pseudo-Differential OTA with R-C Compensation and Cascode Negative Resistance

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

CMOS 1.4 THzΩ 155 Mb/s differential transimpedance preamplifier for optical receiver

Co-design of a Differential Transimpedance Amplifier and Balanced Photodetector for a Sub-Pj/bit Silicon Photonics Receiver.

A Hybrid Integrated TIA and PD for 20-Gb/s Optical Receivers

A 50-MHz Bandwidth and 50.6-dBm OOB-IIP3 Transimpedance Amplifier Based on a Three-Stage Pseudo-Differential OTA

A 12.5 Gb/s 1.38 mW all-inverter-based optical receiver with multi-stage feedback TIA and continuous-time linear equalizer

Inductor-Less Low-Power Low-Voltage Cross-Coupled Regulated-Cascode Transimpedance Amplifier Circuit in CMOS Technology

A CMOS Optoelectronic Transimpedance Amplifier Using Concurrent Automatic Gain Control for LiDAR Sensors

A 50mhz Bandwidth TIA Based on Two Stage Pseudo-Differential OTA with Cascode Negative Resistance and R-C Compensation Technique

An Area-Efficient and Programmable 4 × 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 µm SiGe BiCMOS

An Area-Efficient and Programmable 4 x 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 m SiGe BiCMOS