Abstract:Agile development is considered as an emerging trend in hardware design, and NoC-based multi-IP integrated system has become the mainstream solution. The most critical challenge of this solution is to design a common efficient NoC with ultra-high throughput and low-cost routers to meet the communication characteristics of varied applications. Usually, NoC can not achieve both the gains from high throughput and low cost because high-throughput router architectures need complex virtual channel control logic to ensure that the power consumption and area of buffers will not be too large. Meanwhile, the low-cost router architecture is difficult to achieve higher throughput by increasing the number of buffers due to its simple control circuits. Moreover, most routers in NoC are optimized only for specific applications. To address the problem, this paper presents a “viaduct theory” for throughput optimization and realizes a common NoC router architecture for different scenario requirements (CRAFT router). Firstly, we improve the top boundary of the router throughput with the fully-connected crossbar switch, which is an expensive solution for high throughput. Secondly, we use a method similar to the ring-decouple theory in low-cost routers to reduce the number of router buffers while maintaining high throughput. The experimental results show that the throughput for the low-cost program is 15.4% higher than the conventional router with the same overhead. For the high-performance program, our router saves 50% hardware overhead compared with fully-connected routers with the same throughput; The maximum throughput that can be achieved is 26.3% higher than conventional routers, and 14.2% higher than the other state-of-the-art designs.

A Low-Cost and High-Throughput Virtual-Channel Router with Arbitration Optimization

A Low-Cost and High-Throughput NoC-Aware Chip-to-Chip Interconnection

CRAFT: Common Router Architecture for Throughput Optimization.

A Low Latency Variance NoC Router

Structure Design of Low-Latency Extensible Router in Network on Chip

Performance Enhancement of Routers in Networks-on-Chip Using Dynamic Virtual Channels Allocation

A Hybrid Router Combining Circuit Switching and Packet Switching with Virtual Channels for On-Chip Networks

An Arbitration Approach of Efficient Bandwidth Allocation and Low Latency for SoC Communication

Design of a High-Throughput NoC Router with Neighbor Flow Regulation

A Low-Latency and Low-Power Hybrid Scheme for On-Chip Networks

Mass Message Transmission Aware Buffer-Less Packet-Circuit Switching Router for 3D NoC

Low-power and high-performance adaptive routing in on-chip networks

A Fully Asynchronous QDI Mesh Router Based on 28nm Standard Cells

A Tightly Coupled Network-on-Chip Router Architecture

A Reconfigurable Design of Flexible-arbitrated Crossbar Interconnects in Multi-core SoC System.

TrafficLite: A Configurable On-Chip Interconnect Router Microarchitecture

Design and Evaluation of Virtual Channel-Based Optical-Electrical Interface for Optical Network-on-Chip

Intelligent Bees for QoS Routing in Networks-on-Chip

A NoC Router Design Supporting Quality-of-Service

A Robust FPGA Router with Optimization of High-Fanout Nets and Intra-CLB Connections

High Performance Network-on-Chips (NoCs) Design: Performance Modeling, Routing Algorithm and Architecture Optimization