Abstract:Agile development is considered as an emerging trend in hardware design, and NoC-based multi-IP integrated system has become the mainstream solution. The most critical challenge of this solution is to design a common efficient NoC with ultra-high throughput and low-cost routers to meet the communication characteristics of varied applications. Usually, NoC can not achieve both the gains from high throughput and low cost because high-throughput router architectures need complex virtual channel control logic to ensure that the power consumption and area of buffers will not be too large. Meanwhile, the low-cost router architecture is difficult to achieve higher throughput by increasing the number of buffers due to its simple control circuits. Moreover, most routers in NoC are optimized only for specific applications. To address the problem, this paper presents a “viaduct theory” for throughput optimization and realizes a common NoC router architecture for different scenario requirements (CRAFT router). Firstly, we improve the top boundary of the router throughput with the fully-connected crossbar switch, which is an expensive solution for high throughput. Secondly, we use a method similar to the ring-decouple theory in low-cost routers to reduce the number of router buffers while maintaining high throughput. The experimental results show that the throughput for the low-cost program is 15.4% higher than the conventional router with the same overhead. For the high-performance program, our router saves 50% hardware overhead compared with fully-connected routers with the same throughput; The maximum throughput that can be achieved is 26.3% higher than conventional routers, and 14.2% higher than the other state-of-the-art designs.

A Hybrid Router Combining Circuit Switching and Packet Switching with Virtual Channels for On-Chip Networks

A Low-Latency and Low-Power Hybrid Scheme for On-Chip Networks

Analysis Of A Qos-Based Parallel Packet Switch For Core Routers

An adaptive buffer regulating scheme for on-chip routers

Mass Message Transmission Aware Buffer-Less Packet-Circuit Switching Router for 3D NoC

Performance Enhancement of Routers in Networks-on-Chip Using Dynamic Virtual Channels Allocation

A Low-Cost and High-Throughput Virtual-Channel Router with Arbitration Optimization

A circuit-switched network architecture for network-on-chip

CRAFT: Common Router Architecture for Throughput Optimization.

Low-power and high-performance adaptive routing in on-chip networks

TrafficLite: A Configurable On-Chip Interconnect Router Microarchitecture

Design and Implementation of Multi-Mode Routers for Large-Scale Inter-Core Networks

A novel boundary router structure based on circuit switching

A Fully Asynchronous QDI Mesh Router Based on 28nm Standard Cells

GreenRouter: Reducing Power by Innovating Router's Architecture.

High Performance Hybrid Two Layer Router Architecture for FPGAs Using Network On Chip

On-Chip Router Elements Based on Silicon Hybrid Plasmonic Waveguide

A 320-Gb/S Ip Router With Qos Control

Scheduling Techniques for Hybrid Circuit/packet Networks

A Tightly Coupled Network-on-Chip Router Architecture

Design and Implementation of Single-Buffered Routers