Abstract:Introducing metal fins or foams can both enhance the performance of shell-and-tube phase change thermal energy storage (TES) devices, but the heat transfer mechanisms are different, i.e., heat transfer through a micro-liquid film, named close-contact melting (CCM) mode, brought by fins and reinforced-heat-conduction is triggered by foams. In order to find a method with maximum power density boost for TES devices, an experimental study was conducted to reveal the effect of parallel fins (N = 5, 10) and foams (20 ppi, 40 ppi) attachments on the power density of a shell-and-tube TES device with a heating condition of the 30 °C superheat. Additionally, the finned cases were studied numerically to observe their melting behavior. It was shown that under the working conditions set in this work, the effective use of CCM mode allows addition of fins to win the competition with metal foams for higher power density. At a penalty of energy density loss of only 7 %, the ten-fin-attached TES device achieves a clear boost of power density over 70 % (up to 0.503 W/cm3) and a reduction in melting time of ~47 %. because the CCM mechanism dominates comparing with the two basic heat transfer modes of heat conduction and convection. Introducing metal foams causes both conduction enhancement and convection suppression, thus resulting in high initial power density at the beginning of the melting process and a gradual decrease in power density as the melting process progresses. Properly increasing pore density of metal foams is effective for thermal conductivity enhancement, but too dense structures may lead to deteriorating heat transfer. On balance, taking advantage of CCM mechanism with rational fin design in phase change TES may be a promising and cost-effective way to increase power density, which should be widely used in practice.

Solidification in a shell-and-tube thermal energy storage unit filled with longitude fins and metal foam: A numerical study

Design and operating evaluation of a finned shell-and-tube thermal energy storage unit filled with metal foam

Design and assessments on graded metal foam in heat storage tank: An experimental and numerical study

Solidification Performance of a Latent Heat Storage Unit with Innovative Longitudinal Triangular Fins

Comparative study on heat transfer enhancement of metal foam and fins in a shell-and-tube latent heat thermal energy storage unit

Solidification performance enhancement of encapsulated ice storage system by fins and copper foam

Numerical and optimization study on heat storage and release process of novel fin-metal foam composite structures under periodic heat source

Twisted-fin Parametric Study to Enhance the Solidification Performance of Phase-Change Material in A Shell-and-Tube Latent Heat Thermal Energy Storage System

Experimental and Numerical Studies on Melting/solidification of PCM in a Horizontal Tank Filled with Graded Metal Foam

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Design of non-uniformly distributed annular fins for a shell-and-tube thermal energy storage unit

Melting enhancement in a shell-and-tube latent heat storage unit with staggered fin-foam synergistic configuration

Numerical study of solidification and melting behavior of the thermal energy storage system with non-uniform metal foam and active rotation

Enhanced power density during energy charging of a shell-and-tube thermal storage unit: Comparison between the inclusion of metal fins and foams

Effect of fin-metal foam structure on thermal energy storage: An experimental study

Optimization of adaptive metal foam arrangement in a heat storage tank

Evaluation of different melting performance enhancement structures in a shell-and-tube latent heat thermal energy storage system

Effect of fin number on the melting phase change in a horizontal finned shell-and-tube thermal energy storage unit

Study on the effect of partial filling of foam metal on the solidification performance of ice storage spheres

Discharging performance evaluation and optimization of a latent heat thermal energy storage unit with helm-shaped fin

Investigation and optimization of solidification performance of concentration tube type latent heat storage unit with herringbone wavy fin designs