Abstract:The integrated gate commutated thyristor (IGCT) is promising in dc grids nowadays. However, to meet the increasing demands for handling high fault currents, the turn-off capability of IGCT still needs to be optimized, which is affected by transient turn-off current redistribution significantly. This article proposes an experiment method based on an isolated anode design for detecting the turn-off current redistribution characteristics of IGCT. Influences of ON-state current density and commutation impedance distribution on IGCT's turn-off current redistribution characteristics are explored in detail. The results show that when IGCT's turn-off process satisfies the "hard" gate drive condition, the anode current redistribution gets changed mainly in the current commutation period and the anode voltage rising period of the turn-off process, before IGCT's dynamic avalanche phenomenon happens. Though the anode current distribution experiences large fluctuations during the commutation period, it will achieve a new balancing state at the end of this period, which almost does not affect the following periods. When IGCT goes into the anode voltage rising period, the ON-state current density distribution will affect the turn-off current redistribution. Under the effects of carrier extraction speed differences, the current density distribution throughout the chip tends to reduce its initial difference, which leads to the phenomenon of "current self-balancing." Meanwhile, the region with the highest ON-state current density dominates the anode voltage's building-up speed. To increase IGCT's turn-off capability, improving the ON-state anode current density uniformity utilizing an optimized layout or cell structure is one of the effective methods.

A Novel Detachable Gate Driver Unit with Ultralow Inductance for Integrated Gate Commutated Thyristor

A Novel Multistage Gate Unit of Integrated Gate Commutated Thyristor

Stray Impedance Measurement and Improvement of High-Power IGCT Gate Driver Units

Experimental Investigation on the Turn-Off Failure Mechanism of IGCT

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part I: Anomalous High Current Turn-Off Mode and Safe Operating Area Expansion at Ultra-Low Voltage

Advanced Active Gate Drive for Switching Performance Improvement and Overvoltage Protection of High-Power IGBTs

A novel active gate drive for HV-IGBTs using feed-forward gate charge control strategy

A Novel Hybrid Line Commutated Converter Based on IGCT to Mitigate Commutation Failure for High-power HVDC Application

Experimental Evaluation of IGCT Converters with Reduced Di/dt Limiting Inductance

IGCT AND IEGT--NEW HIGH POWER SILICON SWITCHES SUITABLE FOR STATCOM

Experimental Investigation on the Turn-Off Current Redistribution Characteristics of IGCT Based on an Isolated Anode Design

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part Ⅱ: Hybrid Switch with IGBT Integration and Experimental Validation

Capacitor Switched Gate-Turnoff Thyristor

A Novel Approach for Realizing Hard-Driven Gate-Turn-off Thyristor

An Advanced 4-in Integrated Emitter Turn- off Thyristor with Ultralow Commutation Impedance to Achieve 8 Ka Turn- off Capability: Comprehensive Analysis, Design, and Experiments

Analysis on the Commutation Loop Inductance of Different Cathode Regions in GCT Wafer

A Novel Ultrafast Turn-Off Failure Detection Method of Integrated Gate Commutated Thyristor for VSC Application

The dv/dt Capability of RB-IGCT for Hybrid Line Commutated Converter

Gate Driver Development and Stray Inductance Extraction of 10 kV SiC MOSFET Module for a Switched-Capacitor MMC Application

A 400-V Half Bridge Gate Driver for Normally-off GaN HEMTs with Effective dv/dt Control and High dv/dt Immunity

Resonant Gate Commutated Thyristor (Rgct)-a New Snubberless Turn-off GTO