Abstract:The integrated gate commutated thyristor (IGCT) is promising in dc grids nowadays. However, to meet the increasing demands for handling high fault currents, the turn-off capability of IGCT still needs to be optimized, which is affected by transient turn-off current redistribution significantly. This article proposes an experiment method based on an isolated anode design for detecting the turn-off current redistribution characteristics of IGCT. Influences of ON-state current density and commutation impedance distribution on IGCT's turn-off current redistribution characteristics are explored in detail. The results show that when IGCT's turn-off process satisfies the "hard" gate drive condition, the anode current redistribution gets changed mainly in the current commutation period and the anode voltage rising period of the turn-off process, before IGCT's dynamic avalanche phenomenon happens. Though the anode current distribution experiences large fluctuations during the commutation period, it will achieve a new balancing state at the end of this period, which almost does not affect the following periods. When IGCT goes into the anode voltage rising period, the ON-state current density distribution will affect the turn-off current redistribution. Under the effects of carrier extraction speed differences, the current density distribution throughout the chip tends to reduce its initial difference, which leads to the phenomenon of "current self-balancing." Meanwhile, the region with the highest ON-state current density dominates the anode voltage's building-up speed. To increase IGCT's turn-off capability, improving the ON-state anode current density uniformity utilizing an optimized layout or cell structure is one of the effective methods.

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part Ⅱ: Hybrid Switch with IGBT Integration and Experimental Validation

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part I: Anomalous High Current Turn-Off Mode and Safe Operating Area Expansion at Ultra-Low Voltage

A Novel Mixture Solid-State Switch Based on IGCT with High Capacity and IGBT with High Turn-off Ability for Hybrid DC Breakers.

Experimental Investigation on the Turn-Off Failure Mechanism of IGCT

Analysis and Experiments for IGBT, IEGT, and IGCT in Hybrid DC Circuit Breaker

Transient Current Balancing of Parallel IGCTs in 10-kV/10-kA Hybrid DC Circuit Breaker

Advanced Active Gate Drive for Switching Performance Improvement and Overvoltage Protection of High-Power IGBTs

A Novel Hybrid Line Commutated Converter Based on IGCT to Mitigate Commutation Failure for High-power HVDC Application

Optimum Design of 1.4kv Non-Punch-Through Trench Igbts: the Next Generation of High-Power Switching Devices

IGCT AND IEGT--NEW HIGH POWER SILICON SWITCHES SUITABLE FOR STATCOM

Optimum design of 1.4 kV trench IGBTs-the next generation of high power switching devices

Experimental Investigation on the Turn-Off Current Redistribution Characteristics of IGCT Based on an Isolated Anode Design

Experimental Evaluation of IGCT Converters with Reduced Di/dt Limiting Inductance

Optimal Design of Reverse Blocking IGCT for Hybrid Line Commutated Converter

Researches on 10 kV DC Hybrid Circuit Breaker Based on IGCT Series

A Hybrid Active Gate Drive for Switching Loss Reduction and Voltage Balancing of Series-Connected IGBTs

A High Speed Short-Circuit Protection Circuit with Current Limitation and Soft Turn-Off for High Power IGBTs

Efficiency Improvement of Grid Inverters With Hybrid Devices

Design and Test of the Bidirectional Solid-State Switch for an 160kv/9ka Hybrid DC Circuit Breaker

Low-Cost HVdc Circuit Breaker With High Current Breaking Capability Based on IGCTs

A voltage controlled current source gate drive method for IGBT devices