Abstract:In this work, the effect of molybdenum disulfidenanoparticles on the properties zinc oxideelectron transport layer of organic solar cells is studied. molybdenum disulfidenanoparticles were obtained by laser ablation of MoS2 powder in isopropyl alcohol. To form composite films, nanoparticles were added to a sol–gel zinc oxidesolution with different concentrations.According to scanning electron microscope study, as the concentration of nanoparticles in the film increases, the thickness of the molybdenum disulfidelayer on the zinc oxide surface changes. molybdenum disulfidenanoparticles in the film structure gradually fill the bulk and surface voids inzinc oxide. However, when the concentration exceeds 1%, holes and voids are formed in the film. The absorption spectra of composite films showed that as the concentration of nanoparticles in the film increases, the absorption intensity enhances due to theincrease of the overall thickness. At the same time, zinc oxideoptical band gap width doesnot change, which means the molybdenum disulfidenanoparticles do not affect the electronic structure of zinc oxide. It was shown that the observed changes in the volt-ampere characteristicof organic solar cells with composite films electron transport layer composite films was associated with the influence of molybdenum disulfidenanoparticles on electron transport in organic solar cells.According to impedance spectroscopy study, it was found that molybdenum disulfidenanoparticles at concentration below critical value increases the lifetime of charge carriers and the diffusion coefficient in composite film.

Precursor Molarity Influence on Sprayed Mo-doped ZnO Films for Solar Cells

Effect of solution concentration on surface morphology, optical properties and solar light response of ZnO thin films

Preparation and Characterization of Sprayed Mo-doped ZnO Films

Effect of Mo-doping Concentration on the Physical Behaviour of Sprayed ZnO Layers

A Critical Study of the Optical and Electrical Properties of Transparent and Conductive Mo-doped ZnO Films by Adjustment of Mo Concentration

Synthesis of Conducting Zn1−xMgxO: Al Layers by Spray Pyrolysis for Photovoltaic Application

Unravelling the effects of Zn doping on the physical properties of Co3O4 thin films: experimental study and numerical simulation based on the AZO/ZnS/Co3O4:Zn/Mo/SLG solar cells

Investigation of Molybdenum Doped ZnO Thin Films Prepared by Spray Pyrolysis Technique

Characterization of novel sprayed Zn1−xMgxO films for photovoltaic application

Annealing effect on the structural, opto-electronic and photoluminescence properties of sprayed Zn0.76Mg0.24O films for application in solar cells

Structural, optical, and electrical properties of spray-pyrolyzed MoO3 thin films by varying precursor molarity, as hole-selective contact for silicon-based heterojunction devices

Molybdenum doped tin oxide as electron transport material in air-processable perovskite solar cells

Growth and Physical Behaviour of Zn1−xMgxO Films

A DMSO/MOE mixed solvent system for improving the morphology and efficiency of kesterite solar cell

THE EFFECT OF MOLYBDENUM DISULFIDENANOPARTICLES ON THE PROPERTIES ZINC OXIDE ELECTRON TRANSPORT LAYER OF ORGANIC SOLAR CELLS

Effect of Cu doping on the structural, optical and electrical properties of ZnO thin films grown by RF magnetron sputtering: application to solar photocatalysis

Aluminum Doping Effects on Interface Depletion Width of Low Temperature Processed ZnO Electron Transport Layer-Based Perovskite Solar Cells

Investigating the potential of cobalt-doped zinc oxide (Zn1-xCoxOδ) as a buffer layer for CZTS thin-film solar cells

Synthesis and characterization of Mg-doped ZnO thin-films for photovoltaic applications

Impact of aluminium doping in magnesium-doped zinc oxide thin films by sputtering for photovoltaic applications

High Haze and Low Resistive MgO/AZO Bi-layer Transparent Conducting Oxide for Thin Film Solar Cells