Abstract:In recent years, Zn1−xMgxO has attracted the attention of many researchers as its physical behavior can be suitably controlled by varying the Zn/Mg ratio. Also, it has high stability with low toxicity and the abundance of constituent elements. Further, the band offsets can be tuned to a minimum level with respect to a heterojunction partner by suitably controlling the Zn/Mg ratio. These properties make this material as a potential candidate as a buffer layer in the fabrication of Cu(In,Ga)Se2-based solar cells. In our previous study, Zn1−xMgxO films prepared by spray pyrolysis at 300°C have shown high resistance and optical transmittance with wide energy band gap. However, it is interesting to note that if the films were conducting, then they can also be used as window layers. In the present investigation, Zn0.76Mg0.24O films have been prepared by spray pyrolysis at an optimized substrate temperature of 300°C with different dopant concentrations that vary in the range, 0–6%. X-ray diffraction analysis showed that the films were polycrystalline and exhibited wurtzite crystal structure with a preferential c-axis orientation. The influence of Al doping on the electrical resistivity was found to be significant. The average transmittance of the films was found to be >60% in the visible range with a small variation in the optical energy band gap. The changes occurred in the structure, topography, composition, electrical and optical properties of the layers as a function of dopant concentration have been studied.

Characterization of novel sprayed Zn1−xMgxO films for photovoltaic application

Synthesis of Conducting Zn1−xMgxO: Al Layers by Spray Pyrolysis for Photovoltaic Application

Growth and Physical Behaviour of Zn1−xMgxO Films

Preparation and Characterization of Mg-doped ZnO Thin Films by Sol–gel Method

Mg-composition induced effects on the physical behavior of sprayed Zn1−xMgxO films

Pyrolytic spray deposition of ZnSxSe1−x layers for photovoltaic applications

Annealing effect on the structural, opto-electronic and photoluminescence properties of sprayed Zn0.76Mg0.24O films for application in solar cells

Characterization of ‘al’ Co-Doped Zn1-xMnxO Films Deposited by Spray Pyrolysis

Precursor Molarity Influence on Sprayed Mo-doped ZnO Films for Solar Cells

Synthesis and characterization of Mg-doped ZnO thin-films for photovoltaic applications

Optoelectronic characterization of CuInGa(S)2 thin films grown by spray pyrolysis for photovoltaic application

Facile Preparation of Novel Cu–Zn–S Film by Spray Pyrolysis

Preparation and Characterization of Sprayed Mo-doped ZnO Films

Substrate Temperature Dependent Physical Properties of Sprayed Zn 0.76 Mg 0.24 O Films

Surface characterization of sprayed CuGa x In1−x Se2 layers

Synthesis and characterization of structure, emission and electrical properties of MgxZn1−xO films obtained by spray pyrolysis with different Mg precursors

Substrate Temperature Effect on Charge Transport Performance of ZnO Electron Transport Layer Prepared by a Facile Ultrasonic Spray Pyrolysis in Polymer Solar Cells

In-depth characterization of physical proprieties of SnS:Mg thin films fabricated by ultrasonic spray for solar cell applications

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Structural And Optical Properties Of Sprayed Zn1-Xmnxo Films

Manufacture of different oxides with high uniformity for copper zinc tin sulfide (CZTS) based solar cells