Abstract:Antimony sulfide thin films of thickness ≈500 nm have been deposited on glass slides from chemical baths constituted with SbCl3 and sodium thiosulfate. Smooth specularly reflective thin films are obtained at deposition temperatures from −3 to 10 °C. The differences in the film thickness and improvement in the crystallinity and photoconductivity upon annealing the film in nitrogen are presented. These films can be partially converted into a solid solution of the type Sb2SxSe3−x, detected in X-ray diffraction, through heating them in contact with a chemically deposited selenium thin film. This would decrease the optical band gap of the film from ≈1.7 eV (Sb2S3) to ≈1.3 eV for the films heated at 300 °C. Similarly, heating at 300 °C of sequentially deposited thin film layers of Sb2S3–Ag2Se, the latter also from a chemical bath at 10 °C results in the formation of AgSb(S/Se)2 with an optical gap of ≈1.2 eV. All these thin films have been integrated into photovoltaic structures using a CdS window layer deposited on 3 mm glass sheets with a SnO2:F coating (TEC-15, Pilkington). Characteristics obtained in these cells under an illumination of 850 W/m2 (tungsten halogen) are as follows: SnO2:F–CdS–Sb2S3–Ag(paint) with open circuit voltage (Voc) 470 mV and short circuit current density (Jsc) 0.02 mA/cm2; SnO2:F–CdS–Sb2S3–CuS–Ag(paint), Voc≈460 mV and Jsc≈0.4 mA/cm2; SnO2:F–CdS–Sb2SxSe3−x–Ag(paint), Voc≈670 mV and Jsc≈0.05 mA/cm2; SnO2:F–CdS–Sb2S3–AgSb(S/Se)2–Ag(paint), Voc≈450 mV and Jsc≈1.4 mA/cm2. We consider that the materials and the deposition techniques reported here are promising toward developing ‘all-chemically deposited solar cell technologies.’

Pyrolytic spray deposition of ZnSxSe1−x layers for photovoltaic applications

Structural behaviour of ZnSxSe1−x films deposited by close-spaced evaporation

Characterization of novel sprayed Zn1−xMgxO films for photovoltaic application

Synthesis of Conducting Zn1−xMgxO: Al Layers by Spray Pyrolysis for Photovoltaic Application

Growth and Physical Behaviour of Zn1−xMgxO Films

Surface characterization of sprayed CuGa x In1−x Se2 layers

SnS Films for Photovoltaic Applications: Physical Investigations on Sprayed SnxSy Films

Surface characterization of sprayed CuGa x In 1− x Se 2 layers

Preparation of ZnIn_2S_4 Thin Film by Spray Pyrolysis and Its Photoelectrochemical Characteristic

Synthesis, Characterization, and Photoelectrochemical Study of Cd1−xZnxS Solid Solution Thin Films Deposited by Spray Pyrolysis for Water Splitting

Facile Preparation of Novel Cu–Zn–S Film by Spray Pyrolysis

Investigations on SnS films deposited by spray pyrolysis

Polycrystalline ZnS X Se 1−x Thin Films Deposited on ITO Glass by MBE

Growth of polycrystalline SnS films by spray pyrolysis

Preparation and properties of sprayed CuGa0.5In0.5Se2 thin films

Antimony sulfide thin films in chemically deposited thin film photovoltaic cells

Substrate Temperature Effect on Charge Transport Performance of ZnO Electron Transport Layer Prepared by a Facile Ultrasonic Spray Pyrolysis in Polymer Solar Cells

Optical and structural investigation of ZnS:Cu thin films synthesized by spray pyrolysis

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Vacuum-evaporated PbS:0.03 Zn thin films with varying thicknesses for environmental applications

Fabrication and performance of a polycrystalline ZnCdS/CuGaSe<Subscript>2</Subscript> thin-film solar cell