Turbulence Dissipation of Leakage Flow in Supercritical CO2 Labyrinth Seals

Enbo Zhang,Haicheng Xu,Jing Li,Bofeng Bai

DOI: https://doi.org/10.1016/j.pnucene.2022.104336

IF: 2.461

2022-01-01

Progress in Nuclear Energy

Abstract:Supercritical CO2 (S-CO2) leakage through seals significantly reduces the efficiency of turbomachinery. Improving the labyrinth seal structure is potentially the key to the reduction of the leakage flow rate, but its application is greatly limited by the uncertainties of supercritical CO2 turbulent flow inside the turbomachines with irregular chambers. In this work, we numerically investigated the S-CO2 flow field and dissipation rate of turbulence kinetic energy in stepped labyrinth seals. The RANS method and hexahedral structural mesh were employed. The look-up table containing the real gas properties of carbon dioxide was created and imported into the flow solver. The developed numerical method was validated by experiment results and proved its applicability. We have discovered that the fully developed rotating vortices inside each chamber of the turbomachine significantly increase the turbulent dissipation rate and decrease the fluid carried energy, thus reducing the leakage flow rate. With the seal clearance increasing form 0.5 mm-1.3 mm at pressure ratio pi = 0.7, the vortices development is gradually limited, causing the decrease of turbulent dissipation rate. The leakage rate is found to be heavily dependent on the distance between the seal tip and step. The increase in this distance from 2 mm to 6 mm results in greater space for the continued development of the vortices within the first chamber, thus the enhancement of the turbulent dissipation rate of fluid. Therefore, we defined a geometry coefficient, (delta-b)/s, and analyzed its effects on turbulent dissipation rate and leakage flow rate. With this geometry coefficient increases from 2.8 to 11.2 at pi = 0.7, the maximum turbulent dissipation rate increases from 7.09 x 107 to 1.23 x 108 and the leakage flow rate decreases from 3.98 x 10-2 kg/s to 1.62 x 10-2 kg/s. An improved leakage model characterizing seal geometry, gas properties and compressibility effects was proposed.