Effect of stator rub grooves on leakage performance of a stepped labyrinth seal
Kang Zhang,Xinbo Dai,Xin Yan
2017-01-01
Abstract:With the numerical methods and experimental tests, the effect of stator wear on leakage performance of a labyrinth seal was investigated, and also, the leakage characteristics of the labyrinth seal with stator rub-groove were compared with those of original designs. At four clearances, nine pressure ratios and three groove width to depth ratios, the leakage rates and flow patterns inside the stepped labyrinth seals were numerically obtained. The results show that, in the wear condition, the deviation between the predicted leakage rate and measured value is within 5.58%. As the increase of clearance and stator wear level, the leakage rate is increased rapidly. If the relative rub-groove depth is fixed at 2.5, compared with the original designs, the leakage rates for the wear case at four clearances (1.2mm, 1.7mm, 2.2mm and 2.7mm) are increased by 79.6%, 78.9%, 80.9% and 90.6%, respectively. With the same geometry of rub-groove, the leakage rate is increased with the increase of pressure ratio. However, the relative discharge coefficient is almost kept constant. The existence of rub-groove in the labyrinth seal stator part changes the flow area near the clearance gap, thus the flow pattern inside the seal chamber are altered in contrast to the original design. Correspondingly, the leakage rate in the stepped labyrinth seal is affected by rub-groove geometry, significantly. INTRODUCTION The stepped labyrinth seal is widely used in gas turbine engine to control leakage flow in clearance involved with rotating and stationary parts. Due to the inevitable vibration, centrifugal force, thermal expansion and rotor misalignment, rub damage is commonly occurred in the stator part of labyrinth seal (see Fig.1), especially in the transition operation conditions, for example, starting, shutting down or varying load process. Since the leakage flow in the seal is an important influence factor of the turbomachinery efficiency [1], cooling quality [2], rotordynamics [3], and also heat transfer characteristic [4], investigations of the leakage variations in the stepped labyrinth seal with different stator rub grooves are quite useful for the stepped labyrinth seal design and performance evaluation. Fig.1 Stator rub groove image from Energy Dispersive XRay Spectroscopy [5] To understand the effect of rub groove on leakage performance of the labyrinth seal, a number of researchers have investigated the rub damages in the seal stator under various conditions. Delebarre et al [5] measured the rub groove profiles in a labyrinth seal stator at different rotating speeds, it shows that the incursion speed has a pronounced effect on the rub groove geometry and contact force. Dogu et al [6] carried out a series of numerical simulations to investigate the effect of rub groove shape on the leakage characteristic of labyrinth seal. The results show that the discharge coefficient of the labyrinth seal is increased significantly after stator rubbing. Among different rub groove geometries, the leakage rate increases with triangular, rectangular, acute trapezoidal, isosceles trapezoidal and elliptical profiles successively. Zimmermann et al [7]