Abstract:Measuring particle size distribution accurately down to approximately 1 nm is needed for studying atmospheric 13 new particle formation. The scanning particle size magnifier (PSM) using diethylene glycol as the working fluid has been 14 used for measuring sub-3 nm atmospheric aerosol. A proper inversion method is required to recover the particle size 15 distribution from PSM raw data. Similar to other aerosol spectrometers and classifiers, PSM inversion can be deduced to 16 a problem described by the Fredholm integral equation of the first kind. We tested the performance of the step-wising 17 method, the kernel function method (Lehtipalo et al., 2014), the H&A linear inversion method (Hagen and Alofs, 1983), 18 and the expectation-maximization (EM) algorithm. The step-wising method and the kernel function method were used in 19 previous studies on PSM. The H&A method and the expectation-maximization algorithm were used in data inversion for 20 the electrical mobility spectrometers and the diffusion batteries (Maher and Laird., 1985), respectively. In addition, Monte 21 Carlo simulation and laboratory experiments were used to test the accuracy and precision of the particle size distributions 22 recovered using four inversion methods. When all of the detected particles are larger than 3 nm, the step-wising method 23 may report false sub-3 nm particle concentrations because of assuming an infinite resolution, while the kernel function 24 method and the H&A method occasionally reports false sub-3 nm particles because of using the unstable least square 25 method. The accuracy and precision of the recovered particle size distribution using the EM algorithm are the best among 26 the tested four inversion methods. Compared to the kernel function method, the H&A method reduces the uncertainty 27 while keeping a similar computational expense. The measuring uncertainties in the present scanning mode may contribute 28 to the uncertainties of the recovered particle size distributions. We suggest using the EM algorithm to retrieve the particle 29 size distributions using the particle number concentrations recorded by the PSM. Considering the relatively high 30 computation expenses of the EM algorithm, the H&A method is recommended to be used for preliminary data analysis. 31 We also gave practical suggestions on PSM operation based on the inversion analysis. 32 Atmos. Meas. Tech. Discuss., https://doi.org/10.5194/amt-2018-35 Manuscript under review for journal Atmos. Meas. Tech. Discussion started: 26 February 2018 c © Author(s) 2018. CC BY 4.0 License.

Factors That Govern Sub-3 Nm Particle Measurements in an Airmodus® PSM and a TSI® DEG–SMPS

Parameters governing the performance of electrical mobility spectrometers for measuring sub-3 nm particles

Direct Calibration Using Atmospheric Particles and Performance Evaluation of PSM 2.0 for Sub-10 Nm Particle Measurements

Sizing of Neutral Sub 3 Nm Tungsten Oxide Clusters Using Airmodus Particle Size Magnifier

Dissecting PM sensor capabilities: A combined experimental and theoretical study on particle sizing and physicochemical properties

Electrical Mobility Spectrometer Using a Diethylene Glycol Condensation Particle Counter for Measurement of Aerosol Size Distributions Down to 1 Nm

Remarks on Ion Generation for Cpc Detection Efficiency Studies in Sub-3-Nm Size Range

Nano-hygroscopicity Tandem Differential Mobility Analyzer (Nano-Htdma) for Investigating Hygroscopic Properties of Sub-10Nm Aerosol Nanoparticles

Characterization of Three New Condensation Particle Counters for Sub-3 Nm Particle Detection: ADI Versatile Water CPC, TSI 3777 Nano Enhancer and Boosted TSI 3010

Sub-3nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

Performance comparison of SMPSs with soft X-ray and Kr-85 neutralizers in a humid atmosphere

A Simple Optical Aerosol Sensing Method of Sauter Mean Diameter for Particulate Matter Monitoring

1 Data inversion methods to determine sub-3 nm aerosol size 1 distributions using the Particle Size Magnifier 2

Data Inversion Methods to Determine Sub-3 Nm Aerosol Size Distributions Using the Particle Size Magnifier

Measurement of sub-4 nm particle emission from FFF-3D printing with the TSI Nano Enhancer and the Airmodus Particle Size Magnifier

Sub-3 nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

The Standard Operating Procedure for Airmodus Particle Size Magnifier and Nano-Condensation Nucleus Counter

Influence of Particle Properties and Environmental Factors on the Performance of Typical Particle Monitors and Low-Cost Particle Sensors in the Market of China

Dilution versus fractionation: Separation technologies hyphenated with spICP-MS for characterizing metallic nanoparticles in aerosols

Improvement of Engine Exhaust Particle Sizer (EEPS) Size Distribution Measurement – I. Algorithm and Applications to Compact-Shape Particles

Characterization of Diethylene Glycol-Condensation Particle Counters for Detection of Sub-3 Nm Particles