Abstract:The measurement of airborne particles with sizes below 3 nm is critical, as it helps the understanding of atmospheric nucleation and elucidates important particle synthesis mechanisms in the gas phase. Condensation particle counters (CPCs) have been widely used to measure the concentration of aerosols. However, it is challenging for the CPCs to measure particles below 3 nm due to the insufficient activation of these particles via vapor condensation. Methods have been proposed to increase the saturation ratio of the condensing vapor to promote the detection efficiency of sub-3 nm particles in the CPCs. Different working fluids also make a considerable impact on particle detection. Given the various types of parameters and the wide range of values these parameters can take, modeling studies are needed in searching for the optimal operating conditions of a CPC.In this work, we simulated the sub-3 nm particle activation and growth in a laminar flow CPC using COMSOL Multiphysics®, which has the advantages of simulating complex flow conditions and interfacing with post-processing software such as MATLAB. Our simulation incorporates the influence of temperature-dependent air and working fluid properties on particle activation and the impact of latent heat and non-continuum effects on droplet growth. Following the method introduced by Iida, Stolzenburg and McMurry (2009), particle activation is optimized for a given working fluid and condenser temperature by adjusting the saturator temperature to achieve a homogeneous nucleation rate of 1 s−1. The results, characterized by Dkel,0 (largest particle size that cannot be activated) and Dkel,50 (particle size activated with 50% efficiency), were compared against the analytical Graetz model used in Stolzenburg (1988). Our COMSOL simulations show that glycerine, diethylene glycol, ethylene glycol, 2-aminoethanol, and dimethyl phthalate are the best five working fluids achieving the smallest Dkel,50 among 45 commonly used solvents. The Dkel,50 values simulated by COMSOL under a condenser temperature of 10 °C for the five working fluids are 1.56, 1.88, 1.92, 1.98, and 2.10 nm, respectively, while the values simulated by the analytical Graetz solution differ slightly from 0.4% to 0.7%. The results demonstrate excellent agreement between these two simulation methods. For the five best working fluids activating the same 2.1 nm particles, the droplets can grow to sizes detectable by a second-stage CPC. The sensitivity of the COMSOL solution to the inlet condition and the form of convective diffusion equations is investigated. We also discussed the effect of CPC operating conditions, such as the condenser geometry and flow conditions, on particle activation for optimizing the performance of the CPC in detecting sub-3 nm particles.

Characterization of Diethylene Glycol-Condensation Particle Counters for Detection of Sub-3 Nm Particles

Performance of Diethylene Glycol-Based Particle Counters in the Sub-3 Nm Size Range

Characterization of Three New Condensation Particle Counters for Sub-3 Nm Particle Detection: ADI Versatile Water CPC, TSI 3777 Nano Enhancer and Boosted TSI 3010

Technical Note: Using DEG-CPCs at Upper Tropospheric Temperatures

A new particle size magnifier for detection of sub-2 nm particles

Sub-3nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

Characterization of three new condensation particle counters for sub-3 nm particle detection during the Helsinki CPC workshop: the ADI versatile water CPC, TSI 3777 nano enhancer and boosted TSI 3010

Sub-3 nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

Scanning Supersaturation Condensation Particle Counter Applied As a Nano-Ccn Counter for Size-Resolved Analysis of the Hygroscopicity and Chemical Composition of Nanoparticles

Electrical Mobility Spectrometer Using a Diethylene Glycol Condensation Particle Counter for Measurement of Aerosol Size Distributions Down to 1 Nm

Optimizing the activation efficiency of sub-3 nm particles in a laminar flow condensation particle counter: Model simulation

Sub-3 nm particle size and composition dependent response of a nano-CPC battery

On Operation of the Ultra-Fine Water-Based CPC TSI 3786 and Comparison with Other TSI Models (TSI 3776, TSI 3772, TSI 3025, TSI 3010, TSI 3007)

Experimental Investigation of a Condensation Particle Counter Challenged by Particles with Varying Wettability to Working Liquid

Remarks on Ion Generation for Cpc Detection Efficiency Studies in Sub-3-Nm Size Range

Characteristics of Scanning Flow Condensation Particle Counter (SFCPC): A Rapid Approach for Retrieving Hygroscopicity and Chemical Composition of Sub-10 Nm Aerosol Particles

Laboratory Characterization of A Size-Resolved Cpc Battery to Infer the Composition of Freshly Formed Atmospheric Nuclei

Design and performance characteristics of a condensation particle counter UF-02proto

Laboratory Verification of PH-CPC's Ability to Monitor Atmospheric Sub-3 Nm Clusters

The condensation particle counter battery (CPCB): A new tool to investigate the activation properties of nanoparticles

The Standard Operating Procedure for Airmodus Particle Size Magnifier and Nano-Condensation Nucleus Counter