Abstract:This work introduces the capacitively coupled contactless conductivity detection ( $\text{C}^{{4}}\text{D}$ ) technique into nondestructive testing (NDT) of carbon fiber-reinforced polymer (CFRP) and proposes a new resistance measurement method of CFRP tubes. The proposed method does not require direct contact between the electrodes and the carbon fiber. Therefore, the electrical resistance of CFRP can be measured without the treatments required by traditional electrical methods that may lead to surface or structural damage. The equivalent circuit model of the new method is established, and the challenges are analyzed. Simulation and experiment are conducted with woven fabric CFRP tubes to verify the feasibility of the proposed method, including the range of workable frequency, the effectiveness of the circuit model, and the capability of damage detection. Research results show that a relatively high working frequency is required to accurately measure the interested resistance and sense the resistance change. By selecting a workable frequency, the effectiveness of the circuit model is verified. Research results indicate that the stray capacitance between the electrodes has little effect on resistance measurement, and the capacitor–resistor–capacitor model is still applicable. Research results also verify the feasibility of the proposed method for damage detection. It is able to sense the resistance change resulted from the damage of CFRP, either the conductivity changes in simulation or actual cutting damage in experiment.

Research on Static Characteristics of Capacitance Rod Position Measurement Sensor with Protection Electrodes

Research on Static Characteristics of High Precision Capacitance Rod Position Measurement Sensor

Research on Multi-Electrode Capacitance Rod Position Measurement Sensor for NHR-200

Static Calibration Experiments of Capacitance Control Rod Position Measurement Sensor

Study on Static Characteristics of Array Electrode Capacitance Control Rod Position Measurement Sensor

Analysis on the Influence of Protection Electrodes on the Capacitance Control Rod Position Sensor

Research on Eccentricity Performance of Capacitance Rod Position Measurement Sensor for Measuring Non-Metallic Rod

Research on the Capacitance Control Rod Position Measurement Sensor in NHR-200

Research on Eccentricity Performance of Winding Wire Capacitance Rod Position Measurement Sensor

Built-in Capacitance Sensor for Control Rod Position Measurement in NHR-200 with PEEK Material

Static performance of capacitance control rod position sensor: A review

ANALYSIS ON FRINGE EFFECT OF GROUNDING TYPE CAPACITANCE ROD POSITION SENSOR

Investigation of the Effects of Electrode Geometry on the Performance of C4D Sensor with Radial Configuration.

Dynamic Characteristics of the Capacitance Control Rod Position Measurement Sensor System in NHR-200

Control Rod Position Measurement with Helix-Electrode Capacitance Sensor in Nuclear Heating Reactor

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

A New Electrical Resistance Measurement Method of Carbon Fiber-Reinforced Polymer Tubes Based on C⁴D Technique

Research on Parallel Resistance Measurement Principle for Capacitively Coupled Electrical Resistance Tomography

GROUNDED CONTROL ROD POSITION MEASUREMENT WITH TWO-ELECTRODE CAPACITANCE SENSOR

Control Rod Position Measurement by Two-Electrode Capacitance Sensor in Nuclear Heating Reactor

Modeling and optimal design of sensor for capacitively coupled electrical resistance tomography system