Abstract:This paper reports a novel capacitive sensing method, enabling accurate and self-calibrated measurements for both the amplitude and phase information in sinusoidal motion. The approach constructively utilizes the inherent nonlinearity of a triangular-electrode based (TEB) variable-area sense capacitor. In the case of TEB detection signal, two harmonics exist and each carries information about the motional amplitude and phase. The TEB method robustly extracts the motional amplitude from the ratio of two sideband amplitudes and extracts the motional phase from the subtraction of two sideband phases. This technique is especially valuable for capacitive detection of periodic motion in MEMS resonant devices, such as the resonant accelerometer and Coriolis vibratory gyroscope. The paper presents detailed theoretical analysis and proposes a real-time measurement algorithm implemented in an FPGA device. Experimental results manifest that, compared with the traditional linear method, the sensitivity of the measured amplitude and phase to system parameter variations is highly suppressed up to 95%. Furthermore, an oscillation control system with TEB capacitive detection is introduced for micro-machined vibratory gyroscopes. First measurement results show the amplitude variance of the drive displacement is 120 ppm in an hour while the phase variance is 80 ppm. Allan variance analysis indicates a bias instability of 6.5 degrees/h for the gyroscope output. (C) 2016 Elsevier B.V. All rights reserved.

Research on Eccentricity Performance of Winding Wire Capacitance Rod Position Measurement Sensor

Research on Eccentricity Performance of Capacitance Rod Position Measurement Sensor for Measuring Non-Metallic Rod

Research on Multi-Electrode Capacitance Rod Position Measurement Sensor for NHR-200

Research on Static Characteristics of High Precision Capacitance Rod Position Measurement Sensor

Research on Static Characteristics of Capacitance Rod Position Measurement Sensor with Protection Electrodes

Detecting Eccentricity Fault in Permanent Magnet Synchronous Machines by Means of Zero-Sequence Voltage Component

Study on Static Characteristics of Array Electrode Capacitance Control Rod Position Measurement Sensor

Analysis on the Influence of Protection Electrodes on the Capacitance Control Rod Position Sensor

Nonlinear analysis of cylindrical capacitive sensor used for measuring high precision spindle rotation errors

Mechanism Model for Effect of Eccentricity on Capacitive Control Rod Position Indicators

Research on the Capacitance Control Rod Position Measurement Sensor in NHR-200

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Design and optimization of a new type of contactless radial C4D sensor

Investigation of the Effects of Electrode Geometry on the Performance of C4D Sensor with Radial Configuration.

Static Calibration Experiments of Capacitance Control Rod Position Measurement Sensor

Modeling and optimal design of sensor for capacitively coupled electrical resistance tomography system

A Novel Triangular-Electrode Based Capacitive Sensing Method for MEMS Resonant Devices

ANALYSIS ON FRINGE EFFECT OF GROUNDING TYPE CAPACITANCE ROD POSITION SENSOR

Dynamic Characteristics of the Capacitance Control Rod Position Measurement Sensor System in NHR-200

Built-in Capacitance Sensor for Control Rod Position Measurement in NHR-200 with PEEK Material

Design and Simulation of Sensor for Rotating Arc with Stepless Adjustment Eccentric