Abstract:Bubble nucleation and growth to confinement during flow boiling in microchannels lead to high heat transfer coefficients. They may also create pressure fluctuations that change the superheat driving evaporation and cause flow reversals that promote transient dry-out and uneven distribution of flow between parallel channels. The work described in this paper is part of a programme to develop models for these processes that will aid the design of evaporative cooling systems for devices operating at high heat fluxes. Video observations of water boiling in a single copper channel of rectangular cross-section, 0.38 × 1.6 mm and a heated length 40 mm, were performed. The top side of the channel was a glass window. Results are presented for a heat flux, averaged over the area of the three metal sides, of 210 and 173 W/m2K for incompressible and compressible inlet flow conditions. The inlet pressure was about 1.12 bar and the mass flux was 747.5 kg/m2s for both conditions examined. The results demonstrated the strong influence of compressibility on the mode of bubble detachment and growth and therefore on flow patterns, pressure fluctuations and heat transfer rates. The fluid mechanics of boiling in this size channel were also successfully investigated by 3-D numerical simulation for bubbles growing at a defined rate with a fixed inlet flow rate using the 3-D CFD code FLUENT 6 (no upstream compressibility). The study examined the fluid mechanics of bubble motion with heat transfer, but the mass transfer across the bubble-liquid interface was not simulated in the present work. A small vapour bubble was injected at the wall to ensure the bubble generation is under a quasi nucleation condition. Its growth was driven by an internal source of vapour, at a rate derived by analysis of the experimental measurements of growth. The simulation reproduced well the observed motion and shape of the bubble. The simulation was then extended to model bubbles generated and growing randomly in a 2-D channel.

Experimental Study on Visualized Flow Boiling in a Narrow Rectangular Channel

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Visualization of R1233zd(E) Flow Boiling in Parallel Mini-channels

Visualization of Flow Boiling Experiments on Micro/Nanoscale Structured Surfaces in Microchannel

Heat Transfer Characteristics and Flow Pattern Visualization for Flow Boiling in a Vertical Narrow Microchannel

3-D numerical study of subcooled flow boiling in a horizontal rectangular mini-channel by VOSET

Numerical Investigation of Flow Boiling Characteristics in Narrow Rectangular Channels Using Two-Fluid Eulerian Cfd Model Covering a Wide Range of Pressures

Investigation on visualization and heat transfer performance study of the mini-channel flow boiling

Experimental study of two-phase parameters of subcooled boiling flow in a single-side heated rectangular channel

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Visualization of Flow Patterns and Bubble Behavior During Flow Boiling in Open Microchannels

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Numerical simulation of boiling behavior in vertical microchannels

Experimental Study of Flow Boiling Regimes Occurring in a Microfluidic T-Junction

Numerical Simulation and Experimental Observations of Confined Bubble Growth During Flow Boiling in a Microchannel with Rectangular Cross-Section of High Aspect Ratio

Evaporative annular flow in micro/minichannels: A simple heat transfer model