Abstract:Saturated flow boiling experiments were conducted to investigate the influence of surface wettability on the hydraulic and thermal transport performance in a large width-to-height aspect ratio, one-sided heated rectangular microchannel with deionized water as the working fluid. The contact angles of the bare silicon wafer surface and superhydrophilic surface after deposited by a thin film of 100-nm-thickness silicon dioxide were 65 3 and less than 5 respectively, both of which were utilized as heated surfaces of the microchannel. Parametric experimental studies were carried out with the inlet vapor quality varied from 0.03 to 0.1 and the wall heat fluxes spanned from 4 W/cm(2) to 20 W/cm(2), at various mass fluxes ranging from 120 to 360 kg/m(2) s. High speed flow visualizations were conducted coupled with instrumental measurements to illustrate the effects of heat flux, mass flux and two phase inlet quality on the local heat transfer coefficient, averaged heat transfer performance, two phase flow structure and pressure drop characteristics for surfaces with distinct surface wettability characteristics in the microchannel. Experimental results showed that the local heat transfer coefficient decreased first until approaching a minimum value and then increased towards the exit along the flow direction. Severe heat transfer deterioration was obtained for the bared silicon wafer surface with increased inlet vapor quality and heat flux, resulting from the local dryout phenomenon as can be verified by the flow visualization. While the heat transfer performance of the superhydrophilic surface was relatively constant due to continuous and uniform distribution of the thin liquid film on the heated surface during annular flow dominance and subsequent delay to partial dryout occurrence, which outperformed the untreated hydrophilic surface without additional pressure drop penalty. (C) 2017 Elsevier Ltd. All rights reserved.

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Experimental and Numerical Studies on Enhanced Flow Boiling in Tube with Superwetting Micro-Finned Surfaces

Heat Transfer Characteristics And Flow Pattern Visualization For Flow Boiling In A Vertical Narrow Microchannel

Heat transfer, pressure drop and flow patterns of flow boiling on heterogeneous wetting surface in a vertical narrow microchannel

Effects of Heat Flux, Mass Flux, Inlet Fluid Subcooling, and Channel Orientation on Subcooled Flow Boiling in a High-Aspect-Ratio Rectangular Microchannel

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Experimental Study on Flow Boiling of Deionized Water in a Horizontal Long Small Channel

Experimental Study and Mechanism Analysis of the Flow Boiling and Heat Transfer Characteristics in Microchannels with Different Surface Wettability

Flow Boiling Heat Transfer Characteristics on Micro-Pin-finned Surfaces in a Horizontal Narrow Microchannel

Experimental Study of Saturated Flow Boiling Heat Transfer in an Array of Micro-pin-fins

Experimental Investigation of Flow Boiling in Parallel Mini-channels

LIQUID/TWO-PHASE/VAPOR ALTERNATING FLOW DURING BOILING IN MICROCHANNELS AT HIGH HEAT FLUX

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

Flow boiling phenomena in a single annular flow regime in microchannels (I): Characterization of flow boiling heat transfer

Numerical simulation of boiling behavior in vertical microchannels

Flow Boiling of Low-Pressure Water in Microchannels of Large Aspect Ratio

Experimental Investigation of Subcooled Boiling Characteristics in Microchannels