Abstract:Saturated flow boiling experiments were conducted to investigate the influence of surface wettability on the hydraulic and thermal transport performance in a large width-to-height aspect ratio, one-sided heated rectangular microchannel with deionized water as the working fluid. The contact angles of the bare silicon wafer surface and superhydrophilic surface after deposited by a thin film of 100-nm-thickness silicon dioxide were 65 3 and less than 5 respectively, both of which were utilized as heated surfaces of the microchannel. Parametric experimental studies were carried out with the inlet vapor quality varied from 0.03 to 0.1 and the wall heat fluxes spanned from 4 W/cm(2) to 20 W/cm(2), at various mass fluxes ranging from 120 to 360 kg/m(2) s. High speed flow visualizations were conducted coupled with instrumental measurements to illustrate the effects of heat flux, mass flux and two phase inlet quality on the local heat transfer coefficient, averaged heat transfer performance, two phase flow structure and pressure drop characteristics for surfaces with distinct surface wettability characteristics in the microchannel. Experimental results showed that the local heat transfer coefficient decreased first until approaching a minimum value and then increased towards the exit along the flow direction. Severe heat transfer deterioration was obtained for the bared silicon wafer surface with increased inlet vapor quality and heat flux, resulting from the local dryout phenomenon as can be verified by the flow visualization. While the heat transfer performance of the superhydrophilic surface was relatively constant due to continuous and uniform distribution of the thin liquid film on the heated surface during annular flow dominance and subsequent delay to partial dryout occurrence, which outperformed the untreated hydrophilic surface without additional pressure drop penalty. (C) 2017 Elsevier Ltd. All rights reserved.

High-frequency Alternating Nucleate Boiling of Water Enabled by Microslot Arrays in Microchannels

Flow Boiling in Microchannels Enhanced by Parallel Microgrooves Fabricated on the Bottom Surfaces

Enhanced flow boiling in microchannels integrated with supercapillary pinfin fences

Subcooled flow boiling in ultrahigh-aspect-ratio microchannels for high heat flux cooling

Silicon microchannels flow boiling enhanced via microporous decorated sidewalls

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Effects of Heat Flux, Mass Flux, Inlet Fluid Subcooling, and Channel Orientation on Subcooled Flow Boiling in a High-Aspect-Ratio Rectangular Microchannel

Experimental study of subcooled flow boiling in microchannel heat sinks integrated with different embedded pin fin arrays microstructures

Experimental study on flow boiling characteristics of R134a inside high-heat-flux microchannels

Experimental investigation of two-phase heat transfer in saw-tooth copper microchannels

Numerical study of flow reversal during bubble growth and confinement of flow boiling in microchannels

Heat Transfer Characteristics and Flow Pattern Visualization for Flow Boiling in a Vertical Narrow Microchannel

Enhanced heat transfer coefficient of flow boiling in microchannels through expansion areas

Numerical simulation of boiling behavior in vertical microchannels

Enhancement of Flow Boiling Heat Transfer in Microchannel Using Micro-Fin and Micro-Cavity Surfaces

Highly stable subcooled flow boiling enabled by an opposed wall jet design

Enhance flow boiling in Tesla-type microchannels by inhibiting two-phase backflow

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics