Abstract:Saturated flow boiling experiments were conducted to investigate the influence of surface wettability on the hydraulic and thermal transport performance in a large width-to-height aspect ratio, one-sided heated rectangular microchannel with deionized water as the working fluid. The contact angles of the bare silicon wafer surface and superhydrophilic surface after deposited by a thin film of 100-nm-thickness silicon dioxide were 65 3 and less than 5 respectively, both of which were utilized as heated surfaces of the microchannel. Parametric experimental studies were carried out with the inlet vapor quality varied from 0.03 to 0.1 and the wall heat fluxes spanned from 4 W/cm(2) to 20 W/cm(2), at various mass fluxes ranging from 120 to 360 kg/m(2) s. High speed flow visualizations were conducted coupled with instrumental measurements to illustrate the effects of heat flux, mass flux and two phase inlet quality on the local heat transfer coefficient, averaged heat transfer performance, two phase flow structure and pressure drop characteristics for surfaces with distinct surface wettability characteristics in the microchannel. Experimental results showed that the local heat transfer coefficient decreased first until approaching a minimum value and then increased towards the exit along the flow direction. Severe heat transfer deterioration was obtained for the bared silicon wafer surface with increased inlet vapor quality and heat flux, resulting from the local dryout phenomenon as can be verified by the flow visualization. While the heat transfer performance of the superhydrophilic surface was relatively constant due to continuous and uniform distribution of the thin liquid film on the heated surface during annular flow dominance and subsequent delay to partial dryout occurrence, which outperformed the untreated hydrophilic surface without additional pressure drop penalty. (C) 2017 Elsevier Ltd. All rights reserved.

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Theoretical and Experimental Research on Flow Boiling Heat Transfer in Microchannels for IGBT Modules

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Experimental and Numerical Studies on Enhanced Flow Boiling in Tube with Superwetting Micro-Finned Surfaces

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

Heat Transfer Characteristics and Flow Pattern Visualization for Flow Boiling in a Vertical Narrow Microchannel

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Heat transfer, pressure drop and flow patterns of flow boiling on heterogeneous wetting surface in a vertical narrow microchannel

A New Correlation For Subcooled Flow Boiling Heat Transfer In A Vertical Narrow Microchannel

Forced Convective Boiling Heat Transfer of Water in Vertical Rectangular Narrow Channel

Flow Boiling Heat Transfer Characteristics on Micro-Pin-finned Surfaces in a Horizontal Narrow Microchannel

Numerical simulation of boiling behavior in vertical microchannels

Experimental Study on Flow Boiling of Deionized Water in a Horizontal Long Small Channel

Heat Transfer Characteristics of Water During Flow Boiling in a Vertical Rectangular Mini-channel

Effects of Heat Flux, Mass Flux, Inlet Fluid Subcooling, and Channel Orientation on Subcooled Flow Boiling in a High-Aspect-Ratio Rectangular Microchannel

Flow pattern-based heat transfer analysis of microchannel flow boiling: An experimental investigation

Experimental Study of Saturated Flow Boiling Heat Transfer in an Array of Micro-pin-fins

Heat Transfer Model Based on Flow Pattern During Flow Boiling in Rectangular Microchannels