Abstract:Additive manufacturing (AM), or 3D printing, is drawing considerable contemporary interest due to its characteristics of high material utilization, great flexibility in product design, and inherent moldless process. Arc-based AM (AAM) is a promising AM method with high deposition rate and favorable buildup quality. Components made by AAM are fabricated through superimposed weld beads deposited from metal wire. Unlike laser-based additive manufacturing, AAM is more difficult to control. Because of the large energy input of the energy source and the liquidity of the melting metal material, bottleneck problems like shrinkage porosity, cracking, residual stresses, and deformation occur. Resultant poor geometrical accuracy and mechanical property keep AAM from industrial application. Especially in the aerospace industry, structural and mechanical property specifications are stringent and critical. This paper presents a novel hybrid manufacturing method by using hot-rolling process to assist the arc welding to solve the above problems. Initially, a miniature metamorphic rolling mechanism (MRM) was developed using metamorphic mechanism theory. Configuration and topology of the MRM can change according to the feature of the components to roll the top and lateral surfaces of the bead. Subsequently, three single-pass multilayer walls were built, respectively, for comparison. The rolled results show significant improvement in geometrical accuracy of the built features. Tensile test results demonstrate improvement in mechanical properties. The improved mechanical properties of rolled specimens are superior to wrought material in travel direction. Microstructure comparisons indicate columnar grains observed in vertical direction and fusion zones were suppressed. Eventually, fabrication of a large-scale aerospace component validates the feasibility of industry application for the hybrid manufacturing technology.

Energy Consumption and Mechanical Proprietaries of Hybrid Deposition & Micro-Rolling

Comparison of Energy Consumption Between Hybrid Deposition & Micro-Rolling and Conventional Approach for Wrought Parts

Evaluating the energy properties of the short-flow process based on the industrial metabolism: A case study on the metal 3D printing of hybrid deposition and micro rolling (HDMR)

Investigation of Mechanical Properties for Hybrid Deposition and Micro-Rolling of Bainite Steel

HDMR Technology for the Aircraft Metal Part

Hybrid Direct Manufacturing Method of Metallic Parts Using Deposition and Micro Continuous Rolling

Additive Manufacturing of Ti-6Al-4V Alloy by Hybrid Plasma-Arc Deposition and Microrolling: Grain Morphology, Microstructure, and Tensile Properties

Research on Microstructure and Mechanical Properties of Ti–6Al–4V ELI Fabricated by Hybrid Directed Energy Deposition with In-Situ Rolling and Annealing

Effect of Process Parameters on Stress and Strain of Hybrid Deposition and Micro-Rolling

Research on microstructure and mechanical properties of hybrid plasma arc and micro-rolling additive manufacturing of Inconel 718 superalloy

Influence of in situ micro-rolling on the improved strength and ductility of hybrid additively manufactured metals

Simulation of Microstructure Evolution During Hybrid Deposition and Micro-Rolling Process

Improvement in Geometrical Accuracy and Mechanical Property for Arc-Based Additive Manufacturing Using Metamorphic Rolling Mechanism

Defect-correlated fatigue resistance of additively manufactured Al-Mg4.5Mn alloy with in situ micro-rolling

Strengthening and Toughening of Additively Manufactured Ti-6Al-4V Alloy by Hybrid Deposition and Synchronous Micro-Rolling

Hybrid manufacturing process combining laser powder-bed fusion and forging for fabricating Ti-5Al-5V-5Mo-3Cr-1Zr alloy with exceptional and isotropic mechanical properties

The effects of hot forging on the preform additive manufactured 316 stainless steel parts

Refined microstructure and enhanced mechanical performance of hybrid additive manufacturing Al-Cu-Mg alloys by multi-cycle friction stirring processing

The Carbon Emission Comparison Between Hybrid Manufacturing and Conventional Processes Based on Bionic Computing of Industrial Metabolism

Hybrid Manufacturing by 3D Printing: A Facile Route to Fabricate High-Performance Complex Parts of Low-Fluidity High-Entropy Alloys

A novel direct reduction and alloying process for making additive manufacturing of titanium alloys greener