Abstract:The Ni-Fe-based superalloy GH4169 (Inconel718) is widely used for several critical gas-turbine components which are hot forged. Its microstructure and property are sensitive to the parameter adjustment during hot working process. To obtain required low-cycle fatigue and fracture properties, it is essential that the microstructure is controlled during preheating and heat treatment. The evolution of non-uniform microstructure during hot working is more complicated than that of uniform microstructure. On the other hand, various secondary phases can be observed in GH4169 alloy, thus it is important to investigate the effect of secondary phases on the microstructure evolution during forging process. In this work, the mechanisms of non-uniform microstructure evolution in GH4169 alloy were studied by analyzing the evolution of secondary phases, grain boundary misorientation, grain size and interactions of dislocation. It is found that the volume fraction of 8 phase increases with the increasing of temperature and heating time at the lower temperature. While at the higher temperature, it decreases monotonously with the temperature increasing, but increases first and then decreases to stable value with time increasing. The pinning effect of secondary phases in GH4169 alloy can be concluded that the gamma '' phase and 8 phase precipitated within the grains retain movement of dislocation, the 8 phase precipitated at the grain boundary hinders the nucleation and growth of recrystallized grains, and the carbides limits the grain growth. The frequency of low angle grain boundary decreases with temperature and time increasing, and the mobility of low angle grain boundary increases with temperature increasing. The uniformity of microstructure and the size of equaxied subgrain increases with heating temperature and time increasing. Continuous recrystallization of elongated grain occurs at specific conditions. The mechanisms of non-uniform microstructure evolution during heating process can be concluded as sub grain growth, recrystallized grain growth, and anneal twinning nucleation and growth. The recrystallized grains are formed by the growth of subgrains conducted by the rotation of low angle grain boundary and the movement of dislocation. When the grain growth is pinned, the mechanisms for the energy dissipation is the nucleation and growth of anneal twinning. And the growth of anneal twinning promotes the generation of low angle grain boundaries at the tip of partial anneal twinning.

Coarsening Evolution of gamma ' Phase and Failure Mechanism of Co-Ni-Al-Ti-Based Superalloys During Isothermal Aging

Microstructures and Mechanical Properties of a L12-structured Precipitation Strengthened Co-based Superalloy

Directional coarsening behavior of primary γ′ phase in Ni3Al-based superalloy during aging heat treatment

Simulation of Microstructure Evolution of Ni75al2.9v22.1 Alloy with Progressive Aging Mechanisms

Understanding the Fracture Mechanisms of Ni–Co–Cr-type Superalloys: Role of Precipitate Evolution and Strength Degradation

Mechanisms of Non-Uniform Microstructure Evolution in Gh4169 Alloy During Heating Process

Effect of Annealing Treatment on Microstructure Evolution and Creep Behavior of a Multiphase Ni3Al-based Superalloy

Investigation on γ′ stability in CoNi-based superalloys during long-term aging at 900 °C

Regulating the Coarsening of the Γ′ Phase in Superalloys

Influence of Initial Microstructure on the Γ′-Coarsening Behavior in a Corrosion-Resistant Ni-based Superalloy

Microstructural Stability And Strengthening Mechanism Of A Ni3al-Mo Based Single-Crystal Superalloy Containing Re Element During Long-Time Thermal Aging

Effect of Long-Term Aging on Microstructural Stability and Tensile Deformation of a Fe–Ni-based Superalloy

Effect of Long-Term Aging on the Evolution of Γ' and TCP Phases of a Ni3Al Based Single Crystal Superalloy

Coarsening kinetics of γ′ phase in isothermal aged high Al content Ni–17 at.% Al alloy

Design of Cuboidal Γ/γ' Coherent Microstructure and Its Stability in Low-Density Co-Ni-Al-Mo-Cr-Ti/Nb/Ta Superalloys

Effect of Cr/Mo/W on the Thermal Stability of Γ/γ′ Coherent Microstructure in Ni-Based Superalloys

Effect of alloying elements on the coarsening rate of γʹ precipitates in multi-component CoNi-based superalloys with high Cr content

Microstructure Evolution of Multicomponent γ ′-Strengthened Co-Based Superalloy at 750 °C and 1000 °C with Different Al and Ti Contents

High-Temperature Structural Stabilities of Ni-Based Single-Crystal Superalloys Ni–Co–Cr–Mo–W–Al–Ti–Ta with Varying Co Contents

Mechanical Degradation Behavior and Γ′ Coarsening Mechanism of a Ni-based Superalloy During Long-Term High-Temperature Thermal Exposure

Effects of Microstructure Evolution on the Deformation Mechanisms and Tensile Properties of a New Ni-base Superalloy During Aging at 800 °C