Abstract:This study investigated the interaction between particulate fouling and precipitation fouling on two different enhanced tubes and a plain tube in a shell-and-tube condenser. Three kinds of fouling, including particulate fouling, precipitation fouling, and combined fouling, were measured continuously for more than 720 h in three individual tests, respectively. For the particulate fouling, three tubes suffered a similar fouling process. The asymptotic fouling resistance of the precipitation fouling on enhanced tubes was lower than on the plain tube. However, for the combined fouling, the enhanced tube with a larger start number experienced the greatest fouling. On the same tube, the asymptotic fouling resistances ranked from least to greatest in the following order: particulate fouling, precipitation fouling, combined fouling; and the durations of the induction period ranked as: particulate fouling, precipitation fouling, combined fouling. As for the combined fouling existent in real cooling water systems, the fouling induction period on the plain tube was longer than that of enhanced tubes. Compared with the particulate fouling (SiO2) and precipitation fouling (CaCO3), which had a high bond strength on the tube surface, the combined fouling was soft and easily removed by flow erosion or collision with big particles during the induction period. This indicated that particles mixed in the water could extend the induction period of combined fouling. However, once the combined fouling started to grow, these particles sticking on the heat transfer surface provided nucleation sites for the crystallization process and, thus, increased the fouling thermal resistance significantly. In addition, the results indicated that the variation profile of the accelerated combined fouling after scaling down is similar to the fouling process in a real system. (C) 2019 Elsevier Ltd. All rights reserved.

Experimental study of the fouling deposition on heating surface of narrow rectangular channel

Experimental Study of the Fouling Characteristics in a Pilot-Scale Facility: Influence of the Fouling Surface

Experimental Study on the Interaction Between Particulate Fouling and Precipitation Fouling in the Fouling Process on Heat Transfer Tubes

Experimental and Mechanical Research on Chf Characteristics During Combined/Bottom Quenching in Narrow Rectangular Channel

Experimental Study on Flow Patterns in Narrow Rectangular Channels

Experimental Investigation of Bottom Reflooding and Modeling of Quench Velocity in a Narrow Rectangular Channel

Decoupling Analysis on the Variations of Liquid Velocity and Heat Flux in the Test of Fouling Thermal Resistance

Influence of Deposition and Fouling on Wall Temperature Distribution in Convective Path

Experimental Research on Anti-fouling of Heat Exchanger

Experimental investigation and CFD simulation of reflooding in narrow rectangle channel

On the relation between maximal thermal performance and minimal fouling deposition rate in heat exchanger-like devices

The Characteristics and Correlation of Saturated Pool Boiling Critical Heat Flux for Downward-Facing Plain Heating Surface

Bottom Reflooding Experiments in a Thin Rectangular Channel

Investigation on the fouling mechanism at different water velocities in internally enhanced tubes

Experimental Investigation On Critical Heat Flux From Downward Facing Flat Plate For Different Orientation Angles

Heat Transfer and Fouling Performance of Finned Tube Heat Exchangers: Experimentation Via on Line Monitoring

Development of a heat transfer model for the film boiling regime in a fouling layer

Experimental study on the fouling and heat transfer characteristics of enhanced tubes used in a cooling tower water system with the actual water quality

Experimental investigation on transition boiling during reflooding in a narrow rectangular channel with high wall temperature

Investigation of CaCO 3 fouling in plate heat exchangers

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel