Abstract:Quartz is a widely used material in the field of microelectromechanical systems (MEMS) for fabricating devices such as substrates, probes, and lenses; it is also indispensable as a resonator or oscillator for frequency control in communication and network technologies. However, its development is limited because it is difficult to fabricate an ideal profile for implementation in complex structures. In practice, wet etching is the most effective and extensive method for achieving the expected structure, although dry etching and other special machining techniques have also been investigated. In this study, the dynamic wet etching process was recorded using different ratios of buffered oxide etcher (BOE) solutions as the etchant to reveal the etching mechanism. The experiments were first designed considering the fabrication of samples, experimental conditions, and measurement indicators. Subsequently, the corresponding etch rate, roughness, and surface morphology were investigated to control the process parameters during wet etching. Different etchants exhibit varying etching rates and roughness properties. A smaller proportion of hydrofluoric acid in the BOE solution results in lower etch rate, and vice versa. The roughness (Ra) in the stable stage was not completely consistent with the tendency of the etch rate, whereas the surface morphology and dimensions of the pyramids rationally complied with the roughness trend. Additionally, the results suggested that the three following stages exist during the wet etching process of the z-cut α-quartz wafer; smooth, incremental, and stable. The analysis of the dynamic wet etching process in this study is beneficial for the structural design, manufacturing, and performance of quartz MEMS devices.

Wet Etching in β-Ga2O3 Bulk Single Crystal

Wet etching in β-Ga 2 O 3 bulk single crystals

Wet etching in beta-Ga2O3 bulk single crystals

Wet etching of GaN, AlN, and SiC: a review

One-step Exfoliation of Ultra-Smooth Β-Ga2o3 Wafers from Bulk Crystal for Photodetectors

One-step exfoliation of ultra-smooth β-Ga<sub>2</sub>O<sub>3</sub> wafers from bulk crystal for photodetectors

Etching of Ga2O3: an important process for device manufacturing

A Systematic Study on Dry Etching Process of Germanium for Ge 3D-Fets Applications

Enhancing the Mechanical Strength Ofβ-Ga2o3 with Al Alloying

2 in. Bulk β-Ga2O3 Single Crystals Grown by EFG Method with High Wafer-Scale Quality

Dynamic Process of Wet Etching Using BOE Solutions to Control the Etch Rate, Roughness, and Surface Morphology of a Z-cut Α-Quartz Wafer

Research Development on Wet Etching Technology for Bulk Silicon

Identification and Suppression of Majority Surface States in the Dry-Etched Β-Ga2o3

Etching of Quartz Crystals in Liquid Phase Environment: A Review

Research and Progress of Wet Etching for GaN

Using selective-area growth and selective-area etching on (−102) β-Ga2O3 substrates to fabricate plasma-damage-free vertical fins and trenches

Achieving Porous Germanium from Both P- and N-Type Epitaxial Ge-on-Si Via Bipolar Potentiostatic Etching

Study on Etching of ZnGeP2 Single Crystals

Hvpe Homoepitaxial Growth of High Quality Bulk Gan Using Acid Wet Etching Method and Its Mechanism Analysis

Wet Etching: Controlling the Facet of ZnO During Wet Chemical Etching Its (0001¯) O‐Terminated Surface (small 14/2020)

Heated-H3PO4 etching of (001) β-Ga2O3