Abstract:This paper solves this problem by exploiting an incomplete wall waveguide to reduce the height of circulator by 50%. Although these changes always reduce the frequency bandwidth of the element, the proposed technique optimizes the dimensions of the ferrite and its magnetic characteristics, increases the bandwidth to 400 MHz in 2.9 GHz, which is the idea bandwidth required by many radar systems which has been reached. One of the most important components in the radar and microwave industry that provides transmitting and receiving features for an antenna at the same time is called a circulator. Ferrite circulators are passive three‐port devices in which the RF or microwave signal is transmitted from one port to other port without leakage to the third port. One of the main disadvantages of these waveguide elements is their large dimensions and especially their height, which cannot be used in some systems due to the limited workspace. This paper solves this problem by exploiting an incomplete wall waveguide to reduce the height of the circulator by 50%. These changes always reduce the frequency bandwidth of the element, the proposed technique optimizes the dimensions of the ferrite and its magnetic characteristics and increases the bandwidth to 400 MHz in 2.9 GHz, which is the ideal bandwidth required by many radar systems that have been reached. The ferrite circulator designed and built in this article has a port with a width of 72.13 mm and a height of 17 mm in the S‐band. The method results in a low insertion loss which is less than 0.5 decibels and a high isolation which created more than 20 decibels. The designed and optimized elements have been implemented and the test results verify the theoretical results.

A Novel Circulator Construction with High Multipactor Threshold and High Isolation for Aerospace Applications

A Highly-integrated Non-magnetic Passive Circulator Based on Rotary Traveling-wave Oscillator and Spatio-temporal Conductivity Modulation in 130 Nm CMOS

A Six-Port Circulator Based on Multimode Interference

Design of X-Band Circulator and Isolator for High-Peak-Power Applications

Magnet-Free Miniaturized Circulator Based on Non-Reciprocal Network

Synthesis of Waveguide Single Junction Four-Port Circulators with Turnstile Resonators

Circulator based on spoof surface plasmon polaritons

Study of Millimeter Wave Circulators Based on the Methods of Circular Polarization Isolation

A Magnetless Filtering Circulator With Enhanced Isolation Bandwidth Using Mixed Static and Time-Modulated Resonators

Integrated Active Quasi-Circulator with 27 Db Isolation and 0.8–6.8ghz Wideband by Using Feedback Technique

Multipactor Simulation and Suppression in High-power Ferrite Circulators

Compact Suspension-stripline Circulator for High Power Applications

Folded Circulator with Shorted Y‐junction for High Power Applications

Design of X band multilayer chip microstrip ferrite circulator

High-Power Ridge Waveguide Four-Port Junction Circulator Based on Composite Post Resonators

A Dual Interference-Canceling Active Quasi-Circulator Achieving 36-Db Isolation over 6-Ghz Bandwidth

Compact Four-Port Waveguide Circulator Using Discrete Ferrites for Injection-Locking Magnetron System

A Novel Microwave Ferrite Circulator with Flexible Hybrid Structure and Wide Bandwidth

A Compact X-band Circulator with Embedded Feed Line Based on Substrate Integrated Waveguide

Design and construction of ferrite waveguide circulator with short wall in S band

Design and Fabrication of Self-biased Microstrip Double-Y Junction Circulator