Abstract:As a major obstacle to high performance milling, chatter will inevitably decrease tool life, material removal efficiency and workpiece surface quality. Active control based on actuators for chatter suppression has been developed for a long time. However, in traditional active control, the feedback signals are usually time domain vibration signals, which will mitigate both chatter frequencies and normal frequencies, including rotation frequency and its frequency multiplications. In fact, rotation frequency and its frequency multiplications belong to normal cutting phenomenon, which don't need to be suppressed. Therefore, in traditional control strategies, more energy is wasted due to normal frequencies, which cannot obtain the optimal performance and causes the saturation effect of actuators. In order to solve this problem, this paper realized milling chatter suppression based on the adaptive vibration reshaping, which can precisely modify and control the milling vibration frequencies in frequency domain. Hence, the required control forces provided by actuators will decrease a lot, which can optimize the actuator performance and alleviate the saturation effect. Simulation results show that the adaptive vibration reshaping can suppress chatter frequencies effectively without changing rotation frequency and its frequency multiplications, which satisfies the initial control requirement for optimization of actuator performance. Besides, the convergence analysis, the noise resistance performance analysis, the control delay analysis and the chatter frequencies identification errors analysis are also presented for better facilitation to milling chatter suppression. Finally, contrastive milling tests are implemented on a three-axis milling machine. Experimental results show the designed control algorithm can decrease chatter frequencies, while having a little influence on normal frequencies.

Displacement Difference Feedback Control of Chatter in Milling Processes

Active Control of Milling Chatter Considering the Coupling Effect of Spindle-Tool and Workpiece Systems

Active Control of Milling Chatter Based on the Built-in Force Actuator

A Chatter Mitigation Technique in Milling Based on H∞-ADDPMS and Piezoelectric Stack Actuators

Model Predictive Control Based Chatter Suppression in Milling Process Via Piezoelectric Stack Actuators

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Fuzzy control of milling chatter with piezoelectric actuators embedded to the tool holder

Adaptive Vibration Reshaping Based Milling Chatter Suppression

Chatter Suppression for Milling of Thin-Walled Workpieces Based on Active Modal Control

Active Damping of Milling Chatter Vibration Via a Novel Spindle System with an Integrated Electromagnetic Actuator

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Research on Fuzzy Control for High Speed Milling Chatter of Intelligent Spindle

Model predictive control based active chatter control in milling process

Active Chatter Suppression for Milling Process with Sliding Mode Control and Electromagnetic Actuator

Discrete Time-Delay Optimal Control Method for Experimental Active Chatter Suppression and Its Closed-Loop Stability Analysis

Active chatter control in high speed milling processes based on H∞ almost disturbance decoupling problem

Milling Chatter Mitigation with Projection-Based Robust Adaptive Controller and Active Magnetic Bearing

Time Delay Feedback Control for Milling Chatter Suppression by Reducing the Regenerative Effect

Active Chatter Suppression with Displacement-Only Measurement in Turning Process

Milling Chatter Control Based on Asymmetric Stiffness

Active Suppression of Milling Chatter with LMI-based Robust Controller and Electromagnetic Actuator