Abstract:In this paper, a new terahertz solid-state frequency doubler design method named function-based harmonic impedance optimization method (FHIOM) is reported to improve the simulation iteration speed and accuracy of terahertz solid-state circuit design. Obtaining the matching impedance of the diode part in the optimal operating condition and realizing this impedance through the input-output matching structure are the two main steps in the design of the terahertz doubler. In this design method, harmonic impedance optimization and function-based impedance optimization are applied to quickly obtain the best input and output embedded impedance of the broadband frequency doubler device, which reduces the blindness of tentative optimization. This method innovatively estimates the impedance of the matching structure through the formula, which strengthens the connection between impedance optimization and matching structure realization. Based on the function-based harmonic impedance optimization method, a 220 GHz doubler is designed, processed, and measured. Measured results show that the doubler exhibits a bandwidth from 212 GHz to 230 GHz, with a conversion efficiency of above 15.0% a mean output power of 9.12 mW when supplied with up to 32 mW of input power. A 16 mW peak output power with a 16.4% efficiency was measured at 228 GHz when the input power was 97.55 mW. The frequency doubler design method presented in this work has the advantages of high efficiency and accuracy, which makes it very attractive for practical broadband terahertz applications.

A 220 GHz High-Efficiency Doubler Based on Function-Based Harmonic Impedance Optimization Method

A 170‐ to 260‐GHz Full‐Band Frequency Doubler Realized by Impedance Compression Matching Technique

A Wideband CMOS Frequency Quadrupler with Transformer-Based Tail Feedback Loop.

Full Waveguide Matching Design for 220 GHz Frequency Doubler

Ultralow Power K-Band Frequency Doubler with Differential Output

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

Optimally Matched 189-232 GHz 6.8 dBm Output Power CMOS Frequency Doubler

A 19.5% Efficiency 51–73-Ghz High-Output Power Frequency Doubler in 65-Nm CMOS

An 8.3% Efficiency 96–134 GHz CMOS Frequency Doubler Using Distributed Amplifier and Nonlinear Transmission Line

A Waveguide Reconfigurable Multiband Terahertz Frequency Doubler Using Choke Flange Technology

A Balanced Frequency Doubler Covering 140-220 GHz With an Efficiency of 6.8%-11.6%

24.3 A 200-to-350ghz SiGe BiCMOS Frequency Doubler with Slotline-Based Mode-Decoupling Harmonic-Tuning Technique Achieving 1.1-to-4.7dbm Output Power

A Novel Four-Port Configuration With Improved Efficiency and Power-Handling Capability for Diode-Based Doublers in Submillimeter Waves

Design of a 225ghz Frequency Broadband Solid State Tripler

A 26-38GHz Ultra-Wideband Balanced Frequency Doubler in 0.15µ m GaAs pHEMT Process

Design of a Novel D-Band Frequency Doubler

A High-Power 170 GHz in-Phase Power-Combing Frequency Doubler Based on Schottky Diodes

A 170–230 GHz High-Power Frequency Doubler Based on a GaAs MMIC Process

An Amplifier-Doubler Chain with Conversion Gain Improvement Techniques

Design of a 500 GHz Frequency Tripler with a Probe-based Idle Harmonic Control Technique