Abstract:The cylinder gas film seal between dual-rotor reverse shafts is a new method for sealing aircraft engines that has excellent developmental prospects. We propose a novel method for determining if the sealing ring is fully fluid-lubricated using the average Reynolds equation. Considering surface roughness and centrifugal expansion, we calculated the dynamic pressure, gas film force and friction power consumption with and without inlet pressure differences for each of the four rotation modes. The gas film’s dynamic pressure effects were weakest when the dual rotors rotated in a reverse direction (Mode 3), with or without differences in inlet pressure, since solid contact is most likely to occur under counter-rotation. When the dual rotors were in counter-rotation with an inlet differential pressure of 80 kPa and fixed inner and outer rotor speeds (e.g., 3000 rpm), we calculated the minimum sealing ring film thickness, leakage rate, friction power consumption and gas film force. Changes in outer rotor speed greatly influenced the minimum film thickness and the sealing ring’s performance. Meanwhile, changes in the inner rotor speed had little influence on the minimum film thickness and sealing ring’s lubrication performance. When the speed difference was fixed and the sealing ring was fully fluid-lubricated, lubrication performance changes were mainly affected by changes in centrifugal expansion caused by the outer rotor speed. Given a fixed rotor speed and under dual-rotor counter-rotation, we calculated the effects of inlet differential pressure changes on minimum gas film thickness, leakage rate, friction power consumption, gas film force and other sealing performance variables. Leakage rate and the friction power consumption increase as inlet differential pressure increases. Our results provide a theoretical reference for avoiding solid contact of the cylinder seal between dual-rotor reverse shafts.

Failure Analysis and Improvement Measures of Airplane Actuator Seals

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Parametric Analysis of the Reciprocating Sealing Structure for Aircraft Actuator

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Analysis of material fault of O-ring seal in aircraft cylinder

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

Lip Contact Stress Analysis of Aircraft Actuator VL Seal

Failure Analysis of the Aircraft Accessories Graphite Seal Ring

Increment Frictional Loading Analysis for High-Lift Devices with Seals

FaiIure Behavior AnaIysis of Hydrocracker Heat Exchanger and Its Countermeasures

Characteristic analysis of aircraft glyd-ring seal based on mixed lubrication model

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

Thermal-fluid-structure coupling analysis for valve plate friction pair of axial piston pump in electrohydrostatic actuator (EHA) of aircraft

Research Status and Development Trend of Cylindrical Gas Film Seals for Aeroengines

Fault diagnosis method and experimental research of reciprocating seal based on CFD-GAN-AE

Measurement Technologies of Mechanical and Seal Performance for Aviation Rubber Seals

Progress on Facilities and Methodology to Evaluate Abradable Seal Coatings

Failure analysis on abnormal cracking of the main landing gear door of a civil aircraft

Overview of Materials Used for the Basic Elements of Hydraulic Actuators and Sealing Systems and Their Surfaces Modification Methods