Abstract:The cylinder gas film seal between dual-rotor reverse shafts is a new method for sealing aircraft engines that has excellent developmental prospects. We propose a novel method for determining if the sealing ring is fully fluid-lubricated using the average Reynolds equation. Considering surface roughness and centrifugal expansion, we calculated the dynamic pressure, gas film force and friction power consumption with and without inlet pressure differences for each of the four rotation modes. The gas film’s dynamic pressure effects were weakest when the dual rotors rotated in a reverse direction (Mode 3), with or without differences in inlet pressure, since solid contact is most likely to occur under counter-rotation. When the dual rotors were in counter-rotation with an inlet differential pressure of 80 kPa and fixed inner and outer rotor speeds (e.g., 3000 rpm), we calculated the minimum sealing ring film thickness, leakage rate, friction power consumption and gas film force. Changes in outer rotor speed greatly influenced the minimum film thickness and the sealing ring’s performance. Meanwhile, changes in the inner rotor speed had little influence on the minimum film thickness and sealing ring’s lubrication performance. When the speed difference was fixed and the sealing ring was fully fluid-lubricated, lubrication performance changes were mainly affected by changes in centrifugal expansion caused by the outer rotor speed. Given a fixed rotor speed and under dual-rotor counter-rotation, we calculated the effects of inlet differential pressure changes on minimum gas film thickness, leakage rate, friction power consumption, gas film force and other sealing performance variables. Leakage rate and the friction power consumption increase as inlet differential pressure increases. Our results provide a theoretical reference for avoiding solid contact of the cylinder seal between dual-rotor reverse shafts.

Progress on Facilities and Methodology to Evaluate Abradable Seal Coatings

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

Evaluation of an AlSi-polyester abradable seal coating performance using high-temperature and high-velocity abrasion tests

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Investigation of High-Speed Abrasion Behavior of an Abradable Seal Rubber in Aero-Engine Fan Application

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Scraping Morphology and Adhesion Morphology Analysis of Sealing Coating Based on Scraping Temperature

Abradability Evaluation of NiCrW-BN Gas Path Seal Coating

Design and Development of Cost-Effective Equipment for Tribological Evaluation of Thermally Sprayed Abradable Coatings

Porous spheres enabling excellent high-temperature abradability and long lifetime for abradable seal coating

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Research Status and Development Trend of Cylindrical Gas Film Seals for Aeroengines

Brush seal design and secondary air system modification of a heavy-duty gas turbine to improve the output power

Systematic Experimental Investigation on In-Situ Self-Adaptive Sealing Property of Composite Pressure-Activated Sealant for Curing Minor Tubular Leaks

Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

Current Research and Developing Trends on Auxiliary Gas Supply System with Non-contacting Mechanical Seals

An abradable and anti-corrosive CuAl-Ni/C seal coating for aero-engine

Analysis of the Dynamic Friction of a Gas Face Seal Based on Acoustic Emissions

Gas Leakage Evaluation of Metallic Sealing Surfaces with Annular Morphology

Sealing Performance of Adaptive Contacting Mechanical Seal